Position Indication Gauge Instructions - Livorsi Marine

1 Gauge CONNECTIONS AND CALIBRATION Connect Gauge harness using supplied wiring diagram (Figure 1). Recommended 3 amp fuse. Remove access cap located on back of Gauge housing (Figure 2). Locate adjustment pots (Figure 3). Apply power to boat system and turn Gauge on. Fully lower device (jack plate, trim tab, etc). Adjust low set point pot as needed. Fully raise device (jack plate, trim tab, etc). Adjust high set point pot as needed. Repeat as necessary until pointer is within low set point window and high point set point window (Figure 4). Install Gauge into dash panel and secure with supplied mounting bracket.

2 Tighten mounting bracket nuts to ve (5) inch pounds maximum. Secure any remaining wiring. The Gauge is ready for Center Street Grayslake IL 60030 P: 847-752-2700 F: 847-752-2415 E: (Figure 1 )(Figure 2 )(Figure 3)Black = GroundPurple = Switcher PowerBlue = LightingRecommended 3 amp fuse(Figure 4) Livorsi Position Indication Gauge Instructions EXAMPLELow Set Point WindowHigh Set Point WindowLow Set Point WindowHigh Set Point WindowREV A ECO 28610