Dc Converters With Controlled Device Stresses
Found 5 free book(s)NCP4371 - Qualcomm Quick Charge 3.0 HVDCP Controller
www.onsemi.comfor costly DC−DC converters within the PD. The USB−bus voltage can be controlled in discreet steps from 3.6 V up to 20 V. The output ... Charged Device Model (Note 1) ESDCDM 750 V Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
8/10/12-Bit Voltage Output Digital-to-Analog Converter ...
ww1.microchip.comDigital-to-Analog Converters (DACs), respectively. The devices operate from a single 2.7V to 5.5V supply with an SPI compatible Serial Peripheral Interface. The user can configure the full-scale range of the device to be VREF or 2*VREF by setting the gain selection option bit (gain of 1 of 2). The user can shut down the device by setting the Con-
MCP4902/4912/4922 Data Sheet
ww1.microchip.comDigital-to-Analog Converters (DACs), respectively. The devices operate from a single 2.7V to 5.5V supply with SPI compatible Serial Peripheral Interface. The user can configure the full-scale range of the device to be VREF or 2 * VREF by setting the Gain Selection Option bit (gain of 1 of 2). The user can shut down both DAC channels by using
LT3757/LT3757A (Rev. G) - Analog Devices
www.analog.comLT3757/LT3757A 1 ev For more information www.analog.com n Wide Input Voltage Range: 2.9V to 40V n Positive or Negative Output Voltage Programming with a Single Feedback Pin n Current Mode Control Provides Excellent Transient Response n Programmable Operating Frequency (100kHz to 1MHz) with One External Resistor n Synchronizable to an External Clock n Low …
MBR120VLSF, NRVB120VLSF Schottky Power Rectifier, Surface ...
www.onsemi.comVR, DC REVERSE VOLTAGE (VOLTS) 125 100 65 2.0 4.0 8.0 10 206.0 14 16 18 Figure 8. Typical Operating Temperature Derating* * Reverse power dissipation and the possibility of thermal runaway must be considered when operating this device under any re-verse voltage conditions. Calculations of TJ therefore must include forward and reverse power ...