Quad Comparators
Found 8 free book(s)
LM339 - Single Supply Quad Comparators
www.onsemi.comThese quad comparators feature high gain, wide bandwidth characteristics. This gives the device oscillation tendencies if the outputs are capacitively coupled to the inputs via stray capacitance. This oscillation manifests itself during output transitions (VOL to VOH). To alleviate this situation input resistors < 10 k should be used. The
LT1720/LT1721 - Dual/Quad, 4.5ns, Single Supply 3V/5V ...
www.analog.comDual/Quad, 4.5ns, Single Supply 3V/5V Comparators with Rail-to-Rail Outputs The LT ®1720/LT1721 are UltraFast TM dual/quad compara-tors optimized for single supply operation, with a supply voltage range of 2.7V to 6V. The input voltage range extends from 100mV below ground to 1.2V below the supply volt-age.
LMV331 - Single, Dual, Quad General Purpose, Low Voltage ...
www.onsemi.comSingle, Dual, Quad General Purpose, Low Voltage Comparators The LMV331 is a CMOS single channel, general purpose, low voltage comparator. The LMV393 and LMV339 are dual and quad channel versions, respectively. The LMV331/393/339 are specified for 2.7 V to 5 V performance, have excellent input common−mode ...
Introduction to comparators, their parameters and basic ...
www.st.comuse a dual channel (or quad channel) op amp which can save space in the application. This is possible even if a better alternative is to use comparators that are optimized for this purpose. The op amp is a device which is designed to be used with negative feedback. A major concern is to ensure the stability of such a configuration.
LM339, LM239, LM139, LM2901 Quad Differential …
www.ti.comLM339, LM239, LM139, LM2901 Quad Differential Comparators 1 1 Features 1• Wide Supply Ranges – Single Supply: 2 V to 36 V (Tested to 30 V for Non-V Devices and 32 V for V-Suffix Devices) – Dual Supplies: ±1 V to ±18 V (Tested to ±15 V for Non-V Devices and ±16 V for V-Suffix Devices) • Low Supply-Current Drain Independent of
LM111, LM211, LM311 Differential Comparators datasheet ...
www.ti.comhigh-speed voltage comparators. These devices are designed to operate from a wide range of power-supply voltages, including ±15-V supplies for operational amplifiers and 5-V supplies for logic systems. The output levels are compatible with most TTL and MOS circuits. These comparators are capable of driving lamps or relays and switching
Low-power quad voltage comparator - STMicroelectronics
www.st.comLow-power quad voltage comparator Features Wide single supply voltage range or dual supplies for all devices: +2 V to +36 V or ±1 V to ±18 V Very low supply current (1.1 mA) independent of supply voltage (1.4 mW/comparator at +5 V) Low input bias current: 25 nA typ. Low input offset current: ±5 nA typ.
LPC546xx Product data sheet
www.nxp.comSerial Wire Debug (SWD) with six instruction breakpoints, two literal comparators, and four watch points. Includes Serial Wire Output and ETM Trace for enhanced debug capabilities, and a debug timestamp counter. System tick timer. LPC546xx 32-bit ARM Cortex-M4 microcontroller; up to 512 KB flash and