Spring Return Actuators
Found 5 free book(s)
G01 through G10 Spring-Return Pneumatic Actuators with …
www.emerson.comG7XXX SR, G8XXX SR, and G10XXX SR Spring-Return Series Single Pneumatic Power Module Actuators with M11 or M11 S Hydraulic Override Module. 1.1.2 Normal recommended service interval for this actuator series is five years. NOTE: Storage time …
Double Acting (air to air) and Single Acting KEYSTONE ...
www.emerson.comSpring Return models : up to 1414 Nm Temperature range : -30° to +90°C* with standard components. * An extended temperature range from -30°C to +150°C is available on request. Double Acting (air to air) and Single Acting (spring return), 90° operation, pneumatic actuators General Applications For remote control of any quarter turn
Chapter 5 - Schemes of directional control valves - ISO ...
www.hafner-pneumatik.comIn the scheme below two 2/2-way solenoid valves (S1 and S2) are used to control a cylinder with spring return (single acting) C1. Without actuation both solenoid valves are closed. In order to move the piston rod to the outer position (right) S2 has to be actuated . Compressed air is flowing from the so urce through S2 into the cylinder. In
NI 9472 Datasheet - National Instruments
www.ni.comvariety of industrial devices such as motors, actuators, and relays. There are three connector options for the NI 9472—a 10-position screw-terminal connector, a 10-position spring-terminal connector, and a 25-position DSUB connector. This industry-standard 25-position DSUB connector provides for low-cost cabling to a wide variety of
AT-FM-10K Two-Hand Control Module - Banner Engineering
info.bannerengineering.comthe hazard. The two-hand control actuators must be located in a way that hazardous motion is completed or stopped before the operator can release one or both of the buttons and reach the hazard (see Separation Distance). AT-FM-10K Two-Hand Control Module 2 www.bannerengineering.com - Tel: + 1 888 373 6767 P/N 64137 Rev. I