Search results with tag "Voltage ratings"
Standard Voltage Ranges and Ratings - Powell Ind
www.powellind.comThe equipment nameplates vary in which voltage is used as “Rated Voltage”. For low voltage power circuit breakers and the metal-clad switchgear the voltage rating is the maximum system voltage as required by ANSI C37.12 and C37.20.2. For …
Working Voltage Ratings Applied to Inductors
inductors.ruDocument 712-1 Revised 07/25/08 Why Voltage Ratings Are Not Specified on Inductor Data Sheets Working Voltage Ratings Applied to Inductors Introduction
POWER AND VOLTAGE RATING - Samtec
suddendocs.samtec.comVOLTAGE and POWER Ratings final 101207.doc 1 OF 13 10/18/2007 D-SCOPE-TECH, INC. POWER AND VOLTAGE RATING SCOPE: The purpose of this document is to take the confusion out of power and voltage ratings in
Power MOSFET Basics
www.aosmd.commainly used for <200V voltage rating due to their higher channel density and thus lower on-resistance. Planar MOSFETs are good for higher voltage ratings since on-resistance is dominated by epi-layer resistance and high cell density is not beneficial. The basic MOSFET operation is the same for both structures. Unless specified, the N-channel
Snubber Circuits Suppress Voltage Transient Spikes in ...
pdfserv.maximintegrated.comThe RC network may be replaced by a zener diode that can handle the voltage rating and the power dissipation. However, since the zener is not a fast switching device a capacitor may still be needed in parallel with the zener to handle the high frequency currents. Note that this snubber is not used in Page 5 of 9
Measuring Power MOSFET Characteristics
www.vishay.comThe Power MOSFET used in all the examples is the IRF630. The controlsettings given in the examples are those suitable for the IRF630. The user must modify these values appropriately when testing adifferent device. The IRF630 was selected since it is a typical mid-range device with a voltage rating of 200 V and acontinuous current rating of 9 A