Example: barber
ARDEX CP
filling and repairing areas of indoor and outdoor concrete above, on or below grade. Engineered with Portland cement and select high-performance polymers, ARDEX CP readily bonds to concrete surfaces. It is easy to apply, hardens quickly, is freeze-thaw resistant, and produces a surface finish that is suitable for foot and rubber tire traffic.
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
ARDEX CP
www.ardexamericas.comARDEX CPTM Concrete Patch Description and Usage ARDEX CPTM is a trowel-grade, cementitious topping for filling and repairing areas of indoor and outdoor concrete above, on or below grade. Engineered with Portland
ARDEX MCTM RAPID
www.ardexamericas.comIf the concrete substrate is too uneven to provide a uniform film thickness of the ARDEX MC RAPID (typically CSP #6 or higher), the substrate can be pre-smoothed using ARDEX K 301TM Self-Leveling Exterior Concrete Topping, ARDEX MRPTM Moisture Resistant Patch or ARDEX K 60TM ARDITEX in certain situations.
TECHNICAL GUIDELINES - ARDEX Americas
www.ardexamericas.com310.2R-2013 SCTIG A SPCIIG CCRT SRAC PRPARATI R SAR S, CATIG S, POLR O RAY S, A CCRT RPAIR About ICRI Guidelines The International Concrete Repair Institute (ICRI) was
High-Performance, Waterborne Acrylic Concrete …
www.ardexamericas.comPlease note that this maintenance guide is for the use of ARDEX CG over interior ARDEX toppings. For the maintenance of other ARDEX finishes, please visit
ARDEX Liquid BackerBoard
www.ardexamericas.comARDEX Liquid BackerBoard ® Self-Leveling Underlayment for Interior Wood and Concrete Subfloors Description and Usage ARDEX Liquid BackerBoard® Self …
ARDEX FEATHER FINISH - ARDEX Americas Home
www.ardexamericas.comARDEX FEATHER FINISH® Self-Drying, Cement-Based Finish Underlayment Recommended Tools ARDEX T-2 Ring Mixing Paddle, mixing bucket, margin trowel, steel trowel, razor scraper, and a 1/2” (12 mm) heavy-duty
Self-Leveling Concrete Topping - Ardex
www.ardexamericas.comaddition of ARDEX E 25TM Resilient Emulsion is required to increase the resiliency of the ARDEX K 520. Mix 2 quarts (1.9 L) of ARDEX E 25 with 4.5 quarts (4.25 L) of water for each bag of ARDEX K 520 following the mixing instructions above. Please note that, if ARDEX E 25 is used, the ARDEX K 520 must first cure 24 hours
ARDEX FEATHER FINISH
www.ardexamericas.comARDEX Americas 400 Ardex Park Drive Aliquippa, PA 15001 USA 724-203-5000 888-512-7339 www.ardexamericas.com ARDEX FEATHER FINISH® Self-Drying, Cement-Based
Related documents
DEPARTMENT OF TRANSPORTATION Standard Specifications …
www.dot.ri.govSection 502 Full Depth Cleaning and Sealing of Joints and Cracks Two and One-Half (2½) Inches Nominal Width or Less ... -iv- PART 500 CONCRETE PAVEMENTS (Continued) Page Section 503 Repairing Deteriorated/Damaged Joints Greater Than Two and One-Half (2½) Inches and Less Than or Equal to Eight (8) Inches Nominal Width in Finished Portland ...
SANNDD//TOPPPPIINNGG MMIIXX 3 P UUC - QUIKRETE: …
www.quikrete.comQUIKRETE Sand/Topping Mix consists of a uniformly blended mixture of Portland cement and commercial grade sands, used for repairing and topping damaged horizontal concrete surfaces less than 2" (51 mm) thick. Topping 03 53 00 .
REPAIR, RESTORATION AND STRENGTHENING OF BUILDINGS
www.nicee.orgelasticity than Portland cement concrete. Thus the mortar is not a stiff material for replacing reinforced concrete. It is also re-ported that epoxy is a combustible mate-rial. Therefore it is not used alone. The sand aggregate mixed to form the epoxy mortar provides a heat sink for heat generated and it provides increased modulus of elasticity ...