C106 - Silicon Controlled Rectifiers

1 1 Publication Order Number:C106/DC106 SeriesSensitive Gate SiliconControlled RectifiersReverse Blocking ThyristorsGlassivated PNPN devices designed for high volume consumerapplications such as temperature, light, and speed control; process andremote control, and warning systems where reliability of operation Glassivated Surface for Reliability and Uniformity Power Rated at Economical Prices Practical Level Triggering and Holding Characteristics Flat, Rugged, Thermopad Construction for Low Thermal Resistance,High Heat Dissipation and Durability Sensitive Gate Triggering These are Pb Free DevicesMAXIMUM RATINGS (TJ = 25 C unless otherwise noted)CharacteristicSymbolMaxUnitPeak Repetitive Off State Voltage (Note 1)(Sine Wave, 50 60 Hz, RGK = 1 kW,TC = 40 to 110 C)

2 C106BC106D, C106D1*C106M, C106M1*VDRM,VRRM200400600 VOn-State RMS Current(180 Conduction Angles, TC = 80 C)IT(RMS) On State Current(180 Conduction Angles, TC = 80 C)IT(AV) Non-Repetitive Surge Current(1/2 Cycle, Sine Wave, 60 Hz, TJ = +25 C)ITSM20 ACircuit Fusing Considerations (t = ms) Peak Gate Power(Pulse Width msec, TC = 80 C) Average Gate Power(Pulse Width msec, TC = 80 C)PG(AV) Peak Gate Current(Pulse Width msec, TC = 80 C) Junction Temperature RangeTJ 40 to+110 CStorage Temperature RangeTstg 40 to+150 CMounting Torque (Note 2) exceeding Maximum Ratings may damage the device.

3 MaximumRatings are stress ratings only. Functional operation above the RecommendedOperating Conditions is not implied. Extended exposure to stresses above theRecommended Operating Conditions may affect device VDRM and VRRM for all types can be applied on a continuous basis. Ratingsapply for zero or negative gate voltage; however, positive gate voltage shallnot be applied concurrent with negative potential on the anode. Blockingvoltages shall not be tested with a constant current source such that thevoltage ratings of the devices are Torque rating applies with use of compression washer (B52200F006).

4 Mounting torque in excess of 6 in. lb. does not appreciably lower case-to-sinkthermal resistance. Anode lead and heatsink contact pad are 225 AACASE 077 STYLE 2 See detailed ordering and shipping information in the packagedimensions section on page 5 of this data INFORMATIONSCRs4 A RMS, 200 600 VoltsKGAMARKING DIAGRAM & PIN ASSIGNMENTY= YearWW= Work WeekC106xx = Device Codexx= B, D, D1, M, M1G= Pb Free PackageYWWC106xxG1. Cathode2. Anode3. subject to change without notice. 2016 Littelfuse, 19, 2016 Rev. 10C106 SeriesTHERMAL CHARACTERISTICS (TC = 25 C unless otherwise noted.)

5 CharacteristicSymbolMaxUnitThermal Resistance, Junction to C/WThermal Resistance, Junction to AmbientRqJA75 C/WMaximum Lead Temperature for Soldering Purposes 1/8 in. from Case for 10 SecondsTL260 CELECTRICAL CHARACTERISTICS (TC = 25 C unless otherwise noted.)CharacteristicSymbolMinTypMaxUnit OFF CHARACTERISTICSPeak Repetitive Forward or Reverse Blocking Current(VAK = Rated VDRM or VRRM, RGK = 1 kW)TJ = 25 CTJ = 110 CIDRM, IRRM 10100mAmAON CHARACTERISTICSPeak Forward On State Voltage (Note 3)(ITM = 4 A)VTM Trigger Current (Continuous dc) (Note 4)(VAK = 6 Vdc, RL = 100 W)TJ = 25 CTJ = 40 CIGT 1535200500mAPeak Reverse Gate Voltage (IGR = 10 mA)VGRM Trigger Voltage (Continuous dc) (Note 4)(VAK = 6 Vdc, RL = 100 W)TJ = 25 CTJ = 40 Non Trigger Voltage (Continuous dc) (Note 4)(VAK = 12 V, RL = 100 W, TJ = 110 C)

6 VLatching Current(VAK = 12 V, IG = 20 mA, RGK = 1 kW)TJ = 25 CTJ = 40 CIL Current (VD = 12 Vdc)(Initiating Current = 20 mA, RGK = 1 kW)TJ = 25 CTJ = 40 CTJ = +110 CIH CHARACTERISTICSC ritical Rate of Rise of Off State Voltage(VAK = Rated VDRM, Exponential Waveform, RGK = 1 kW, TJ = 110 C)dv/dt V/ms3. Pulse Test: Pulse Width ms, Duty Cycle 2%.4. RGK is not included in Order Number:C106/DSpecifications subject to change without notice. 2016 Littelfuse, 19, 2016 Rev. 10C106 Series+ Current+ VoltageVTMIDRM at VDRMIHS ymbolParameterVDRMPeak Repetitive Off State Forward VoltageIDRMPeak Forward Blocking CurrentVRRMPeak Repetitive Off State Reverse VoltageIRRMPeak Reverse Blocking CurrentVTMPeak On State VoltageIHHolding CurrentVoltage Current Characteristic of SCRA node +on stateReverse Blocking Region(off state)Reverse Avalanche RegionAnode Forward Blocking RegionIRRM at VRRM(off state)DCDCJUNCTION TEMPERATURE 110 (AV) AVERAGE ON STATE CURRENT (AMPERES)HALF SINE WAVERESISTIVE OR INDUCTIVE to 400 (AV) AVERAGE ON STATE CURRENT (AMPERES)

7 HALF SINE WAVERESISTIVE OR INDUCTIVE LOAD50 TO T , CASE TEMPERATURE ( C)P , AVERAGE ON STATE POWER DISSIPATION (WATTS)(AV)Figure 1. Average Current DeratingFigure 2. Maximum On State Power Dissipation3 Publication Order Number:C106/DSpecifications subject to change without notice. 2016 Littelfuse, 19, 2016 Rev. 10C106 Series110095-40-25-1020535508010110TJ, JUNCTION TEMPERATURE ( C)65 GTmIFigure 3. Typical Gate Trigger Current versusJunction TemperatureFigure 4. Typical Holding Current versusJunction , JUNCTION TEMPERATURE ( C) 5. Typical Gate Trigger Voltage versusJunction TemperatureFigure 6.

8 Typical Latching Current versusJunction Temperature, GATE TRIGGER CURRENT ( A)10100095-40-25-10205355080100110TJ, JUNCTION TEMPERATURE ( C)65 HmI, HOLDING CURRENT ( A)10100095-40-25-10205355080100110TJ, JUNCTION TEMPERATURE ( C)65 LmI, LATCHING CURRENT ( A), GATE TRIGGER VOLTAGE (V)4 Publication Order Number:C106/DSpecifications subject to change without notice. 2016 Littelfuse, 19, 2016 Rev. 10C106 SeriesThe dimensional diagrams below compare the critical dimensions of the Littelfuse C-106 package with competitive devices. It has been demonstrated that the smaller dimensions of the Littelfuse package make it compatible in most lead-mount and chassis-mount applications.

9 The user is advised to compare all critical dimensions for mounting C-106 PackageCompetitive C-106 BSCPACKAGE INTERCHANGEABILITYORDERING INFORMATIOND evicePackageShipping C106 BGTO 225AA(Pb Free)500 Units / BoxC106 DGTO 225AA(Pb Free)500 Units / BoxC106D1G*TO 225AA(Pb Free)500 Units / BoxC106 MGTO 225AA(Pb Free)500 Units / BoxC106M1G*TO 225AA(Pb Free)500 Units / Box*D1 signifies European equivalent for D suffix and M1 signifies European equivalent for M Order Number:C106/DSpecifications subject to change without notice. 2016 Littelfuse, 19, 2016 Rev. 10C106 SeriesPACKAGE DIMENSIONSTO 225 CASE 77 09 ISSUE ZNOTES:1.

10 DIMENSIONING AND TOLERANCING PER , CONTROLLING DIMENSION: 077-01 THRU -08 OBSOLETE, NEW 2:PIN B A MKFCQHVGSDJRU1322 ( ) ( )BMDIM MINMAXMIN TYP5 Order Number:C106/DSpecifications subject to change without notice. 2016 Littelfuse, 19, 2016 Rev. products are not designed for, and shall not be used for, any purpose (including, without limitation, automotive, military, aerospace, medical, life-saving, life-sustaining or nuclear facility applications, devices intended for surgical implant into the body, or any other application in which the failure or lack of desired operation of the product may result in personal injury, death, or property damage) other than those expressly set forth in applicable Littelfuse product documentation.