How to Use a Multimeter - learn.sparkfun

probe is conventionally plugged in to. This port allows the measurement of current (up to 200mA), voltage (V), and resistance (Ω). The probes have a banana type connector on the end that plugs into the multimeter. Any probe with a banana plug will work with this meter. This allows for different types of probes to be used.

Fullscreen Download

Tags:

Multimeter, Ports

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of How to Use a Multimeter - learn.sparkfun

Documents from same domain

Light-Emitting Diodes (LEDs) - learn.sparkfun

learn.sparkfun.com

If you connect an LED directly to a current source it will try to dissipate as much power as it's allowed to draw, and, like the tragic heroes of olde, it will destroy itself. That's why it's important to limit the amount of current flowing across the LED. For this, we employ resistors.

Delo

How to Read a Schematic - learn ... - SparkFun Electronics

learn.sparkfun.com

Overview Schematic Symbols (Part 1) Schematic Symbols (Part 2) Name Designators and Values Reading Schematics Resources and Going Further Overview Schematics are our map to designing, building, and troubleshooting circuits. Understanding how to read and follow schematics is an important skill for any electronics engineer.

Overview, Schematics, Overview schematic

Series and Parallel Circuits - learn.sparkfun

learn.sparkfun.com

Series and Parallel Circuits a learn.sparkfun.com tutorial Available online at: http://sfe.io/t81 Contents Series and Parallel Circuits Series Circuits Parallel Circuits

Series, Circuit, Parallel, Series and parallel circuits, Series and parallel circuits series circuits parallel circuits

Resistors - learn.sparkfun

learn.sparkfun.com

Surface mount resistor decoding ... SMD resistors have their own value-marking system. Decoding the Color Bands Through-hole, axial resistors usually use the color-band system to display their value. Most of these resistors will have four bands of color circling the resistor.

Surfaces, Mount, Learn, Marking, Resistor, Sparkfun, Surface mount resistors, Resistors learn

How to Use an Oscilloscope - learn.sparkfun

learn.sparkfun.com

Basics of O-Scopes The main purpose of an oscilloscope is to graph an electrical signal as it varies over time. Most scopes produce a two-dimensional graph with time on the x-axis and voltage on the y-axis.

Oscilloscopes, How to use an oscilloscope

Serial Peripheral Interface (SPI) - learn.sparkfun

learn.sparkfun.com

Programming for SPI Resources and Going Further Introduction Serial Peripheral Interface (SPI) is an interface bus commonly used to send data between microcontrollers and small peripherals such as shift registers, sensors, and SD cards. It uses separate clock and data lines, along with a select line to choose the device you wish to talk to.

Programming