Example: air traffic controller

INSTALLATION & OPERATING INSTRUCTIONS FOR US …

INSTALLATION & OPERATING . INSTRUCTIONS FOR. C US. ARUF, ARPF, ADPF, AEPF. SERIES air handler . Made in the USA by: Goodman Manufacturing Company, IO-286B 2550 North Loop West, Suite 400 - Houston, Texas 77092 6/06. or 2004-2006 Goodman Manufacturing Company, INDEX IMPORTANT SAFETY INSTRUCTIONS . INTRODUCTION .. 2 Recognize Safety Symbols, Words, and Labels REPLACEMENT PARTS .. 2 The following symbols and labels are used throughout this SAFETY INSTRUCTIONS .. 2 manual to indicate immediate or potential hazards. It is the WARNINGS .. 2-3 owner's responsibility to read and comply with all safety MODEL IDENTIFICATION.

series heat kit. this air handler does not have factory installed electric heat. electric heat is available as an accessory. if installing this option, the only heat kits that can be used are the hkr series as indicated below: note: the amana® brand ehk, ecb, edb, and edk kits are not approved for use with these air handlers.

Tags:

  Operating, Installation, Instructions, Handlers, Air handler, Installation amp operating instructions for us

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of INSTALLATION & OPERATING INSTRUCTIONS FOR US …

1 INSTALLATION & OPERATING . INSTRUCTIONS FOR. C US. ARUF, ARPF, ADPF, AEPF. SERIES air handler . Made in the USA by: Goodman Manufacturing Company, IO-286B 2550 North Loop West, Suite 400 - Houston, Texas 77092 6/06. or 2004-2006 Goodman Manufacturing Company, INDEX IMPORTANT SAFETY INSTRUCTIONS . INTRODUCTION .. 2 Recognize Safety Symbols, Words, and Labels REPLACEMENT PARTS .. 2 The following symbols and labels are used throughout this SAFETY INSTRUCTIONS .. 2 manual to indicate immediate or potential hazards. It is the WARNINGS .. 2-3 owner's responsibility to read and comply with all safety MODEL IDENTIFICATION.

2 4 information and INSTRUCTIONS accompanying these symbols. PRODUCT DESCRIPTION .. 4 Failure to heed safety information increases the risk of UNIT INSPECTION .. 4 serious personal injury or death, property damage and/or ELECTRIC HEAT .. 5 product damage. HKR INSTALLATION .. 5. WARNING. LOCATION .. 5. HAZARDS OR UNSAFE PRACTICES COULD RESULT IN. DUCTWORK .. 6. PROPERTY DAMAGE, PRODUCT DAMAGE, SEVERE. ELECTRICAL SUPPLY WIRE AND MOP .. 6 PERSONAL INJURY OR DEATH. REFRIGERANT LINES .. 7. AEPF MOTOR ORIENTATION .. 8 WARNING. CONVERSION TO DOWNFLOW .. 8. THE UNIT MUST HAVE AN UNINTERRUPTED, CONVERSION TO HORIZONTAL.

3 9 UNBROKEN ELECTRICAL GROUND TO MINIMIZE THE. CONDENSATE REMOVAL .. 10 POSSIBILITY OF PERSONAL INJURY IF AN ELECTRICAL. ACHIEVING 2% LOW LEAKAGE RATE .. 10 FAULT SHOULD OCCUR. THE ELECTRICAL GROUND. ARUF/ARPF/ADPF MOTOR .. 10 CIRCUIT MAY CONSIST OF AN APPROPRIATELY SIZED. ELECTRICAL WIRE CONNECTING THE GROUND LUG. AEPF MOTOR .. 10. IN THE UNIT CONTROL BOX TO THE BUILDING. THERMOSTAT WIRING DIAGRAMS .. 12-13 ELECTRICAL SERVICE PANEL. OTHER METHODS OF. THERMOSTATS .. 14 GROUNDING ARE PERMITTED IF PERFORMED IN. ACCORDANCE WITH THE NATIONAL ELECTRIC CODE . INTRODUCTION (NEC)/ AMERICAN NATIONAL STANDARDS INSTITUTE.

4 Checking Product Received (ANSI)/ NATIONAL FIRE PROTECTION ASSOCIATION . Upon receiving the product, inspect it for damage from (NFPA) 70 AND LOCAL/STATE CODES. IN CANADA, shipment. Claims for damage, either shipping or concealed, ELECTRICAL GROUNDING IS TO BE IN ACCORDANCE. should be filed immediately with the shipping company. WITH THE CANADIAN ELECTRIC CODE CSA Check the product to determine if it is correct. In the event FAILURE TO OBSERVE THIS WARNING CAN RESULT IN. an incorrect product is shipped, it must be returned to the ELECTRICAL SHOCK THAT CAN CAUSE PERSONAL. supplier and must NOT be installed.

5 The manufacturer INJURY. assumes no responsibility for INSTALLATION of incorrectly shipped products. WARNING. Before Beginning INSTALLATION HIGH VOLTAGE! DISCONNECT ALL POWER BEFORE SERVICING OR. Carefully read all INSTRUCTIONS for the INSTALLATION prior to INSTALLING THIS UNIT. MULTIPLE POWER SOURCES. installing product. Make sure each step or procedure is MAY BE PRESENT. FAILURE TO DO SO MAY CAUSE. understood and any special considerations are taken into PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH. account before starting INSTALLATION . Assemble all tools, hardware and supplies needed to complete the INSTALLATION .

6 Some items may need to be purchased locally. Make sure WARNING. everything needed to install the product is on hand before DUE TO HIGH SYSTEM PRESSURE AND ELECTRICAL. starting. SHOCK POTENTIAL, INSTALLING AND THE SERVICING. REPLACEMENT PARTS AIR CONDITIONING SYSTEMS CAN BE HAZARDOUS. Ordering Parts ONLY QUALIFIED AND PROFESSIONALLY TRAINED. PERSONNEL ARE PERMITTED TO INSTALL OR SERVICE. When reporting shortages or damages, or ordering repair THIS EQUIPMENT. OBSERVE ALL WARNINGS. parts, give the complete product model and serial numbers CONTAINED IN THIS MANUAL AND LABELS/TAGS.

7 As stamped on the product. Replacement parts for this ATTACHED TO THE EQUIPMENT. product are available through your contractor or local distributor. For the location of your nearest distributor consult the white business pages, the yellow page section of the local telephone book, or contact the following: SERVICE PARTS DEPARTMENT. GOODMAN MANUFACTURING COMPANY, 2550 NORTH LOOP WEST, SUITE 400. HOUSTON, TEXAS 77092. (713) 861 2500. 2. WARNING WARNING. THIS PRODUCT IS FACTORY SHIPPED FOR USE WITH A ONLY INDIVIDUALS MEETING THE REQUIREMENTS OF. 208-240/1/60 ELECTRICAL POWER SUPPLY.

8 THIS AIR AN ENTRY LEVEL TECHNICIAN AS SPECIFIED BY THE. HANDLER MUST NOT BE RECONFIGURED TO OPERATE AIR CONDITIONING AND REFRIGERATION INSTITUTE. WITH ANY OTHER POWER SUPPLY. (ARI) MAY USE THIS INFOMRATION. ATTEMPTIMG TO. INSTALL OR REPAIR THIS UNIT WITHOUT SUCH. WARNING BACKGROUND MAY RESULT IN PRODUCT DAMAGE, PERSONAL INJURY, OR DEATH. WHEN INSTALLING OR SERVICING THIS EQUIPMENT, SAFETY CLOTHING, INCLUDING HAND AND EYE. PROTECTION, IS STRONGLY ADVISED. IF INSTALLING WARNING. THIS EQUIPMENT IN AN AREA THAT HAS SPECIAL SAFETY. TO PREVENT THE RISK OF PROPERTY DAMAGE, REQUIREMENTS (HARD HATS ETC.)

9 , OBSERVE THESE. PERSONAL INJURY, OR DEATH, DO NOT STORE. REQUIREMENTS. TO PROTECT THE UNIT WHEN. COMBUSTIBLE MATERIALS OR USE GASOLINE OR. WELDING CLOSE TO THE PAINTED SURFACES, THE USE. OTHER FLAMMABLE LIQUIDS OR VAPORS IN THE. OF A QUENCHING CLOTH IS STRONGLY ADVISED TO. VICINITY OF THIS APPLIANCE. PREVENT SCORCHING OR MARRING OF THE. EQUIPMENT FINISH. WARNING. THE UNITED STATES ENVIRONMENTAL PROTECTION. AGENCY ( EPA ) HAS ISSUED VARIOUS REGULATIONS. REGARDING THE INTRODUCTION AND DISPOSAL OF. REFRIGERANTS INTRODUCED INTO THIS UNIT. FAILURE TO FOLLOW THESE REGULATIONS MAY HARM.

10 THE ENVIRONMENT AND CAN LEAD TO THE IMPOSITION. OF SUBSTANTIAL FINES. THESE REGULATIONS MAY. VARY BY JURISDICTION. A CERTIFIED TECHNICIAN MUST. PERFORM THE INSTALLATION AND SERVICE OF THIS. PRODUCT. SHOULD QUESTIONS ARISE, CONTACT. YOUR LOCAL EPA OFFICE. CARBON MONOXIDE POISONING HAZARD. Special Warning for INSTALLATION of Furnace or Air Handling Units in WARNING Enclosed Areas such as Garages, Utility Rooms or Parking Areas DO NOT CONNECT TO OR USE ANY DEVICE THAT IS Carbon monoxide producing devices (such as an automobile, space NOT DESIGN CERTIFIED BY GOODMAN FOR USE WITH heater, gas water heater, etc.)


Related search queries