Example: barber
Installation Manual L2 - Valor Fireplaces
This appliance is certifi ed to ANSI Z21.88/CSA 2.33 American National Standard / CSA Standard for Vented Gas Fireplace Heaters for use in Canada and USA, and to CGA 2.17-91 High Altitude Standard in Canada. This appliance is for direct vent installations. This appliance complies with CSA P.4.1-15 Testing
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
ZERO CLEARANCE + INSERT SERIES - Valor Fireplaces
www.valorfireplaces.comthe heritage look of your home. Also available as a freestanding stove. Although traditional in design, these modest cast iron fronts look great in traditional and contemporary settings. Beautiful attention to detail is apparent as flames reflect off the cast contours and immaculate detailing, radiating warmth. To see more examples,
INSTALLATION & OWNER’S MANUAL Portrait
www.valorfireplaces.comlocated, manufactured (mobile) home where not prohibited by local codes. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certifi ed kit is used. Ce guide est disponible en français sur demande. This appliance is a domestic room-heating ...
INSTALLATION & OWNER’S MANUAL Portrait
www.valorfireplaces.comoperating instructions contained in your owner’s manual Replacement manuals are available by contacting the Valor Service Department at 1-800-468-2567 or visit www.valorfi replaces.com.
GV60 Remote Electronic Ignition and Control System
www.valorfireplaces.comGV60 Remote Electronic Ignition and Control System INSTALLER TROUBLESHOOTING GUIDE electrode cable antenna correct position of antenna Figure 3 No Ignition; No Tone: No Ignition; One 5 second continuous tone (7 short beeps might be heard prior to the 5 second tone): B) C) 1. Receiver 1. ON/OFF switch is in OFF position. 2. Loose wire. 3 ...
INSTALLATION & OWNER’S MANUAL G3 with - Valor …
www.valorfireplaces.coma chimney serving a separate solid fuel burning appli-ance. Each gas appliance must use a separate vent system. Common vent systems are prohibited. Inspect the external vent cap on a regular basis to make sure that no debris, plants, trees, shrubs are inter-fering with the air fl ow. Do not operate this appliance with the glass door
Related documents
INSTALLATION INSTRUCTIONS - Lennox
www.lennox.comG40UH(X) units are CSA International certified to ANSI Z21.47 and CSA 2.3 standards. In the USA, installation of gas furnaces must conform with lo-cal building codes. In the absence of local codes, units must be installed according to the current National Fuel Gas Code (ANSI-Z223.1). The National Fuel Gas Code is available from the following ...
Packaged Rooftop Air Conditioners - Trane
www.trane.comexchangers is 10,000 cycles by ANSI Z21.47. This is the standard required by both UL and AGA for cycle test requirements. Trane requires the design to be tested to 2½ times this current standard. The drum and tube design has been tested and passed over 150,000 cycles which is over 15 times the current ANSI cycling requirements.
Installation Manual
downloads.hearthnhome.comSTANDARD: ANSI Z21.97-2017, CSA 2.41-2017 A. Appliance Certification D. Noncombustible Materials Specification Material which will not ignite and burn. Such materials are those consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or any combination thereof. Materials that are reported as passing ASTM E 136,
INSTALLATION & SERVICE MANUAL - Lochinvar
www.lochinvar.comfor Hot Water Supply Systems, ANSI Z21.22 and the Standard CAN1-4.4 Temperature, Pressure, Temperature and Pressure Relief Valves and Vacuum Relief Valves. The combination temperature and pressure relief valve must be marked with a maximum set pressure not to exceed the maximum working pressure of the water heater. The combination
Upflow/ Horizontal Left/Right, Downflow Single and 2–Stage ...
www.trane.com(b) Central Furnace heating designs are certified to ANSI Z21.47 / CSA 2.3 — latest edition. (c) Based on U.S. government standard tests. (d) Refer to the Installer's Guide. (e) The above wiring specifications are in accordance withNational Electrical Code; however, installations must comply local codes. MODEL S8X1B060M3PSAA S8X1B060M4PSAA ...
DRYER VENTING SPECIFICATIONS - Whirlpool
www.whirlpool.com(reference ANSI Z21.5.1 standard). These standards require testing at the maximum-rated exhaust vent conditions that are published in the product literature for each individual model. The designation for the UL or CSA listing can be found on or adjacent to …
ANSI Z223.1 National Fuel Gas Code
ahmad-tomasz.weebly.com(1) American National Standard Installation of Gas Appliances and Gas Piping, ANSI Z21.30 (NFPA 54) (2) Installation of Gas Piping and Gas Equipment on Industrial Premises and Certain Other Premises, ANSI Z83.1 (NFPA 54A) (3) Fuel Gas Piping, ASME B31.2 The first edition of the code was issued in 1974. It combined the requirements of the three