Example: tourism industry
Model of Aortic Blood Flow Using the Windkessel E ect
lution for the blood pressure P(t), and the numerical solution, using an ODE solver in MATLAB (code in Appendix). Figure 8: Analytical and Numerical solutions for 2-Element Windkessel Model. Figure 8 shows the aortic blood pressure for the numerical solution. Note that, as expected, the blood pressure varies between the range of 80-120mmHg.
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
106 IEEE REVIEWS IN BIOMEDICAL ENGINEERING, …
isn.ucsd.edu106 IEEE REVIEWS IN BIOMEDICAL ENGINEERING, VOL. 3, 2010 Dry-Contact and Noncontact Biopotential Electrodes: Methodological Review Yu Mike Chi, Student Member, IEEE, Tzyy-Ping Jung, Senior Member, IEEE, and
Introduction to the SkyWater PDK
isn.ucsd.edupoly contact nitride poly cut layer (NPC) Understanding the SkyWater PDK via1 via2 via3 via4 0.36µm 0.36µm 0.845µm 0.845µm 1.26µm metal1 metal2 metal3 metal4 metal5 mcon ... sky130_fd_bd_sram openRAM foundry (not yet available) dual−port SRAM bit cell. NVRAM Libraries Understanding the SkyWater PDK buried floating gate
Related documents
Variable Volume Chilled Water Pumping System Controls
daytonashrae.orgPumping System • Single Chiller, Single Constant Speed Primary Pump, bypass loop with no valve, Variable Speed Secondary Pump. • The primary pump pumps water through the chiller. The secondary pump pulls water from the primary system and pumps it to the coils. • Add a Water Differential Pressure Transmitter near the end of the
Massey Ferguson Hydraulic System Operators Manual
www.jensales.comvalve, No. 1, Fig, 49, all the way out and place the hydralever in constant pumping. The combined flow would then be controlled by the auxiliary control valve, One single-acting or one double-acting cylinder can be operated, To return the system to normal operation, move the hydralever from the constant pumping posi
Chilled-Water System Decisions - Trane
www.trane.comthe operating pressures of the system pumps. This is accomplished by installing a bypass line with a small pressure drop. The bypass allows water to flow in either direction and is used to indicate chiller and primary pump sequencing in this system arrangement (Figure 1). Chillers and constant flow primary pumps
CHAPTER 3: PUMPING STATION 3.1 INTRODUCTION
cpheeo.gov.inarrangements are shown in Figure 3.1. Source: CPHEEO, 1993 Figure 3.1 Typical drywell and wetwell installations 3.2.1 Dry Pit The size of the dry pit should be adequate for the number of pumps planned and should be such as to handle the sewage load at the desired pumping capacity. Allowance should also be made for future requirements of ...