Example: dental hygienist

Mounting Bracket for HMM100 Quick Reference Guide

GENERAL INSTALLATION. The Mounting Bracket for HMM100 humidity modules provides 1. Attach the module to the Bracket with four screws; see convenient installation and handling protection for the Figure 2. HMM100 . Note that the Bracket does not provide IP rated protection. Quick Reference Guide The Mounting Bracket includes the following parts: - metal Mounting Bracket with four screws for attaching the module - plastic lid with two screws - screws and clamps for holding the probe cable and the power/signal cable - Abiko connector ( push-on male terminal) to be used with unshielded power/signal cables - DIN rail clip and screw Mounting Bracket for Humidity Module HMM100 . Figure 2 Module Mounted in the Bracket 2. Connect the power/signal cable to the screw terminals.

QUICK REFERENCE GUIDE Mounting Bracket for Humidity Module HMM100 – Metal backplate and a plastic lid for ... The mounting bracket includes the following parts: - metal mounting bracket with four screws for attaching the module - plastic lid with two screws - screws and clamps for holding the probe cable and the ... 11/30/2009 3:12:02 PM ...

Tags:

  Guide, Reference, Part, Quick, 2009, Mounting, Quick reference guide, Brackets, Mounting bracket for, Quick reference guide mounting bracket for

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of Mounting Bracket for HMM100 Quick Reference Guide

1 GENERAL INSTALLATION. The Mounting Bracket for HMM100 humidity modules provides 1. Attach the module to the Bracket with four screws; see convenient installation and handling protection for the Figure 2. HMM100 . Note that the Bracket does not provide IP rated protection. Quick Reference Guide The Mounting Bracket includes the following parts: - metal Mounting Bracket with four screws for attaching the module - plastic lid with two screws - screws and clamps for holding the probe cable and the power/signal cable - Abiko connector ( push-on male terminal) to be used with unshielded power/signal cables - DIN rail clip and screw Mounting Bracket for Humidity Module HMM100 . Figure 2 Module Mounted in the Bracket 2. Connect the power/signal cable to the screw terminals.

2 Refer to the HMM100 User's Guide for wiring instructions. 3. Attach the probe cable and the power/signal cable to the right side of the Bracket using the screws and metal clips. See Figure 3 for the suggested placement. Figure 1 Mounting Bracket Parts Metal backplate and a plastic lid for a single HMM100 module Can be installed on a DIN rail Figure 3 Connecting Cables Vaisala 2009 . All rights reserved. *M211079EN*. 4. Make sure that the shield of the power/signal cable makes DIMENSIONS. good contact with the Bracket . If your cable is unshielded, you can provide the earth connection by using a separate cable and the Abiko connector provided (visible in Figure 3). A. 5. Attach the plastic lid over the Bracket and tighten the two screws. 6. Mount the Bracket in the desired location with two screws or using the DIN rain clip.

3 7. Verify the installation: power up the module and check the output reading. A. Figure 4 Bracket Dimensions Visit our Internet pages at Ref. M211079EN-A.


Related search queries