Example: confidence
WATER & WASTEWATER
Epoxy coating (heavy duty) of ductile iron fittings and accessories. Requirements and ... water or gas applications ISO 4179 Ductile iron pipes and fittings for pres-sure and non-pressure pipelines – Cement mortar lining ISO 4633 Rubber seals – Joint rings for water supply, drainage and sewerage pipelines – ... Design rules and type testing.
Tags:
Information
Domain:
Source:
Link to this page:
Related documents
Coatings MasterSeal 350 - Master Builders Solutions
assets.master-builders-solutions.comEPOXY MORTAR 1.Mix the two components of MasterSeal 350 using the recommended procedures under the Mixing section. 2.Slowly add up to five parts by volume of oven-dried sand to one part of mixed epoxy. 3.For larger applications, a paddle-type (mortar) mixer may be used. However, the A and B components must first be mixed together using
03 35 00 - Concrete Finishing - Bay Area Rapid Transit
webapps.bart.gov301. When using epoxy mortar, conform with applicable requirements of ACI 503.4. B. Surface Defects: 1. Repair of surface defects shall begin immediately after form removal. For repair with epoxy mortar, concrete shall be dry. 2. Surface defects are defined to include: form-tie holes, air voids or pockets, bug holes with
USG Solutions USG DUROCK BRAND CEMENT BOARD WITH …
www.usg.comfortified mortar or Type I organic adhesive. USG Durock® Brand Cement Board with EdgeGuard is preferred by many applicators as a base for directly applied finishes, tile, stone and thin brick used in building exteriors. The 1/2 in. (12.7 mm) and 5/8 in. (15.9 mm) panels are Underwriters Laboratories Inc. (UL)
9HUVD%RQG 3URIHVVLRQDO7KLQ 6HW0RUWDU 7'6 …
images.thdstatic.comStone Mortar for the installation of ceramic and porcelain tile in submerged applications. For additional information, contact Custom Technical Services. When setting moisture sensitive natural stone, cement or agglomerate tile use (%0 /LWH (SR[\%RQGLQJ0RUWDU 6ROLGV or &(* /LWH 100% Solids Commercial Epoxy Grout .
PRODUCT DATA SHEET: POWER-TREAD - SERIES 237 - Tnemec
production.tnemec.comMortar Application: The Part C mortar aggregate (S237-0301C) is based on a nominal amount calculated at 60-80 lbs. per gallon when mixed or a 6.5 to 1–9.0 to 1 (rock to resin) ratio by weight. Part C mortar aggregate purchased from Tnemec is packaged in 50 lb. bags.
USG DUROCK BRAND CEMENT BOARD SYSTEMS
www.usg.comBrittle coatings, such as epoxy coatings, are not recommended for use with USG Durock® cement board. USG Durock® cement board is intended for use with tile, thin brick and exterior stucco coatings only. 6. Maximum dead load for ceiling system is 7.5 psf. 7. Steel framing must be 20-gauge equivalent or heavier. USG DUROCK® BRAND CEMENT BOARD