INCRA
INCRAThe only table saw fence with patented Automatic Lead screw Positioning ControlTMSafety . . . . . . . . . . . . . . . . . . . . 2Fasteners and Hardware Lists . . . . 2Rail Assembly . . . . . . . . . . . . . . 4Base Mount Assembly . . . . . . . . . 6Fence Assembly . . . . . . . . . . . . . 8Final Calibration . . . . . . . . . . . . . . 9Blade Guard Adjustments . . . . . . 11Extension Table . . . . . . . . . . . . . 11Auxiliary Fence Mounting . . . . . . 12Maintenance . . . . . . . . . . . . . . . 12Warranty . . . . . . . . . . . . . . . . . . 12 CONTENTSPlease read this owner s manual and keep it at hand for : The INCRA TS-LS system consists of three packages.
screws. Insert the screws through each of the (8) holes on the red sub-base on your INCRA LS Positioner Base and loosely thread a #10-32 hex nut onto each screw. Slide the hex nuts on all (8) screws into the T-slots on the base support panel. See Fig. 12 and Detail 12A. Center the LS base on the support panel. (Edge of LS should
Download INCRA
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: