Transcription of 04048-TFH 3600 Parts List - Spinner II® Products
{{id}} {{{paragraph}}}
Example: biology
04048-TFH 3600 Parts List - Spinner II® Products
16 gpm at 60 psigModel 36006,000 cc Dirt CapacityInstallation InstructionsParts ListService InstructionsBulletin 73360 Oil Supply to CentrifugeOil supplyshould, in general, be taken from the highestpressure, hottest source available on the dirty side of thefull-flow oil filter. A3 4-in. pipe or #12 hose supply lineshould be used with a full-opening ball valve installedat the centrifuge oil inlet so that the unit can be isolatedfor service without shutting down the engine. Preferredpressure is 60 to 80 psig, but the Spinner II centrifugewill operate efficiently at 45 to 90 psig. An internal idlecut-out valve closes to prevent low oil pressure duringlow-speed Oil Return to SumpLevel Control Base (LCB) PreferredThe air-operated control in the LCB ( part No.)
Maintenance Procedure 1. Stop the flow of oil to the centrifuge by closing any installed inlet valves, or stopping the engine. Ensure the centrifuge has come to
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: