3A, Ultra-Low Dropout Voltage Regulator - Richtek

The RT9059 is a high performance positive voltage regulator designed for use in applications requiring very low input voltage and very low dropout voltage at up to 3A. It operates with a VIN as low as 1V and VDD voltage 3V with programmable output voltage as low as 0.8V. The RT9059 features ultra low dropout, ideal for applications where

  Ultra, High

500mA, Low Dropout, Low Noise Ultra-Fast Without Bypass ...

500mA, Low Dropout, Low Noise Ultra-Fast Without Bypass Capacitor CMOS LDO Regulator Ordering Information Marking Information For marking information, contact our sales representative directly or through a Richtek distributor located in your area. General Description The RT9013 is a high-performance, 500mA LDO regulator,

  Dropout, Regulators

300mA, Ultra-Low Noise, Ultra-Fast CMOS LDO Regulator

zUltra Fast Response in Line/Load Transient zQuick Start-Up (Typically 50 μs) z<0.01μA Standby Current When Shutdown zLow Dropout : 220mV @ 300mA zWide Operating Voltage Ranges : 2.5V to 5.5V zTTL-Logic-Controlled Shutdown Input zLow Temperature Coefficient zCurrent Limiting Protection zThermal Shutdown Protection

  Fast, Transient

1 Copyright Richtek Technology 2015

SG003-01 OCT 2015 4 5 Copyright Richtek Technology 2015 鋰離子電池的優勢 與其他電池類別相比，鋰離子電池優勢眾多： → 重量輕

Dual-Channel Synchronous DC/DC Step-Down Controller with ...

Low-Side Gate Driver Output for Channel 2. LGATE2 swings between GND and LDO5. 12 VIN Power Input for 5V and 3.3V LDO Regulators and Buck Controllers. 13 LDO5 5V Linear Regulator Output. LDO5 is also the supply voltage for the low-side MOSFET and analog supply voltage for the device. 14 BYP1 Switch-over Source Voltage Input for LDO5. 15 LGATE1

  Regulators

October 2021

05 Adjustable output voltage via resistor divider and Vin max ≤ 6.5V: This selection table is suitable for general linear regulator building block with extra flexibility of adjustable output voltage and other features such as low noise or high

  Voltage, Adjustable

70mΩ/55mΩ, 3A/2.5A/2A/1.5A/1A/0.5A High-Side Power ...

70mΩ/55mΩ, 3A/2.5A/2A/1.5A/1A/0.5A High-Side Power Switches with Flag General Description The RT9742 is a cost-effective, low-voltage, single N-MOSFET high-side Power Switch IC for USB application. Low switch-on resistance and low supply current are realized in this IC. The RT9742 integrates an over-current protection circuit,

Programmable USB Type-C PD Controller - Richtek

Richtek Technology Corporation Street, Chupei City Hsinchu, Taiwan, R.O.C. Tel: (8863)5526789

1.5MHz, 1A, High Efficiency PWM Step-Down DC-DC Converter

1.5MHz, 1A, High Efficiency PWM Step-Down DC-DC Converter General Description The RT8010/A is a high efficiency Pulse-Width-Modulated (PWM) step-down DC-DC converter. Capable of delivering 1A output current over a wide input voltage range from 2.5V to 5.5V, the RT8010/A is ideally suited for portable electronic devices that are powered from 1 ...

  Converter, Dc converter

DC/DCコンバータ設計セミナー - ROHM

dropout） • 通常は推奨範囲に準ずる • t j maxにより、v o、i o、t aの条件により制限を 受ける ③出力精度（v ref精度） • 意味：±%で示される誤差 • 固定タイプは固定値（v o）、可変タイプはv ref v in max v o 有効入力範囲 v dropout 出力範囲 入力範囲 v ref

  Dropout

AP2210 Description Pin Assignments - Diodes Incorporated

300mA RF ULDO REGULATOR Description The AP2210 is a 300mA ULDO regulator which provides very low noise, ultralow dropout voltage (typically 250mV at 300mA), very low - standby current (1µA maximum), and excellent power supply ripple rejection (PSRR 75dB at 100Hz). This device is used in battery

  Dropout

LT3042 - 20V, 200mA, Ultralow Noise, Ultrahigh PSRR RF ...

Ultrahigh PSRR RF Linear Regulator The LT®3042 is a high performance low dropout linear regulator featuring LTC’ s ultralow noise and ultrahigh PSRR architecture for powering noise sensitive RF applications. Designed as a precision current reference followed by a high performance voltage buffer, the LT3042 can be easily

  Dropout, Low dropout

RTL-SDR Blog V3 Datasheet

Improved ESD protection on the RF front end ... The V3 makes use of a low noise LDO and one of the GPIO pins on the RTL2832U to provide a 4.5V bias ... The V3 uses an LDO that has a much lower ‘dropout’ voltage compared to the typical AMS1117 LDO used on most dongles. Hence the V3 should run better on long USB extension cables.

  Dropout

1. General description - NXP

An embedded low-dropout voltage regulator allows the device to be connected directly to a battery. In addition, a power switch is included to supply power to a secure IC. ... Integrated RF interface for NFCIP-1 up to 424 kbit/s Possibility to communicate on th e RF interface above 424 kbit /s using external analog components

  Dropout

GUITAR WIRELESS SYSTEM - Xviveaudio

RF Exposure Statement: This transmitter must not be ... dropout. The li-ion batteries help makes the U2 wireless system environmentally friendly that can last up to 5 hours per charge. The chassis is made out of a durable abs plastic ... low battery which requires immediate power charge. During power charging, the red LED on the transmitter ...

  Dropout

ADRV9026 System Development User Guide (Rev. PrA)

1.3 V, and 1.0 V. These supplies are fed directly to the power inputs for some blocks and buffered by internal low dropout (LDO) regulators for other functions for maximum performance. The digital processing blocks are supplied by a 1.0 V source. In addition, a

  Dropout, Low dropout

BM83 Bluetooth® Stereo Audio Module DS

• Integrated 3V and 1.8V Configurable Switching Regulator and Low-Dropout (LDO) RF/Analog • Frequency Spectrum: 2.402 GHz to 2.480 GHz • Receive Sensitivity: -90 dBm (2 Mbps EDR, at 0.01% BER) • Programmable Transmit Output Power: – Up to +10.4 dBm (typical) for Basic Data Rate (BDR) – Up to +9.2 dBm (typical) for Enhanced Data Rate ...

  Dropout

FEATURES DESCRIPTIO U - Analog Devices

does not rise in dropout as it does with many other regulators. In addition to fast transient response, the LT1963 regulators have very low output noise which makes them ideal for sensitive RF supply applications. Output voltage range is from 1.21V to 20V. The LT1963 regulators are stable with output capacitors as low as 10µF.

  Devices, Dropout, Analog devices, Analog

Also compatible with Jeep Gladiator JT User’s Guide

• Set Transfer Case LOW ratio: Use this setting to change the calibration for 4LOW gear ratio. Use the left arrow and cruise +/- buttons to raise or lower the value, then select it (left arrow and cruise on/off) to save the new setting. Submenu Tire: TPMS and tire size options • Set TPMS: Turn the tire pressure monitoring system on or off.