Transcription of INSTALLATION INSTRUCTIONS E600 SERIES MAGNETIC LOCK
{{id}} {{{paragraph}}}
Example: marketing
INSTALLATION INSTRUCTIONS E600 SERIES MAGNETIC LOCK
801 Avenida Acaso, Camarillo, Ca. 93012(805) 494-0622 Fax: (805) E-mail: E600 SERIES MAGNETIC lock is mounted to the underside of the header, on the stop side of the door. An inswing mounting kit (optional) can be used when mounting on the hinge side of the :\ INSTALLATION INST\Electromagnetic Locks\EXCEL\ REV A3 05-18 Page 1 Any suggestions or comments to this instruction or product are welcome. Please contact us through our website or email INSTALLATION INSTRUCTIONSE600 SERIES MAGNETIC LOCKO utswingElectrical INSTRUCTIONS :Use properly fused U. L. Listed Power SupplyDo not install a diode in parallel with any MAGNETIC lock. A diodewill cause a delay when releasing the door and residual magnetismto SDC recommends the use of a DC power supply, atransformer with an adjacent mounted full wave bridge rectifiermay be used. A significant drop will occur when using a full wavebridge low voltage condition will cause erratic operation of theoptional board using a full wave bridge rectifier all access controls and/orrelease contacts must be located between the MAGNETIC lock and rectifierto ensure quick Specifications:Dual Voltage12 or 24 VDCP ower Consumption500mA@12 VDC250mA@24 VDCDS Door Status Sensor SPDT, 500mA@30 VDCLS Lock Status Sensor SPDT, 2A@30 VDCQ uick MountInterlockingMounting AssemblyMounting ScrewsArmatureInterlockingMounting PlateFrameP:\
801 Avenida Acaso, Camarillo, Ca. 93012 (805) 494-0622 • Fax: (805) 494-8861 www.sdcsecurity.com • E-mail: service@sdcsecurity.com The E600 Series magnetic lock is mounted to the underside of the header, on the stop side of the
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: