Transcription of Jamming on X- Band Radar - IOSR-JEN
{{id}} {{{paragraph}}}
Example: bankruptcy
Jamming on X- Band Radar - IOSR-JEN
IOSR Journal of Engineering (IOSRJEN) ISSN (e): 2250-3021, ISSN (p): 2278-8719 Vol. 04, Issue 04 (April. 2014), ||V2|| PP 08-12 International organization of Scientific Research 8 | P a g e Jamming on X- Band Radar Mahmoud Yahia Hussein, AbdelrasoulJabar Alzubaidi 1, Department Of Electronics Engineering, 1 SudanAcademy Of Sciences 2,Electronics Engineering School, Sudan University Of science And technology Abstract: - Radar Jamming is the intentional emission of radio frequency signals to interfere with the operation of a Radar by saturating its receiver with noise or false information. In this paper Jamming technique is used to jam x-band Radar frequency. To accomplish this goal it's proposed to design circuit using Basic Stamp, ATmega16 Microcontroller, two X-Band motion detector modules, LCD and Digi's X-CTU software. In this design we considered one of x-band motion detector module as a Radar and the second x-band motion detector as jammer circuit which uses Doppler frequency principle and generates GHZ frequency.
Jamming on X- Band Radar International organization of Scientific Research 9 | P a g e The ATmega16A is a low-power CMOS 8-bit microcontroller based …
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Wrist based HRM Reference Design, Exams Section B, Electrical, THE 8051/8052 MICROCONTROLLER, DATASHEET #TDAX070502 ELECTRONIC ASSISTANT® CONFIGURATION, Electronic, DLP-7970ABP, Design, Phase-Shifted Full Bridge DC/DC Power Converter, Phase-Shifted Full Bridge DC/DC Power Converter Design, Development, A Low Cost Wireless Temperature, A Low Cost Wireless Temperature Monitoring, Image acquisition and color recognition system