Transcription of (PROJECT STANDARDS AND SPECIFICATIONS)
{{id}} {{{paragraph}}}
Example: bachelor of science
(PROJECT STANDARDS AND SPECIFICATIONS)
Page : 1 of 21. KLM Technology Group Rev: 01. Project Engineering April 2012. Standard KLM Technology Group #03-12 Block Aronia, SPECIFICATIONS FOR PUMP INSPECTION. Jalan Sri Perkasa 2. Taman Tampoi Utama 81200 Johor Bahru (PROJECT STANDARDS AND SPECIFICATIONS). Malaysia TABLE OF CONTENT. SCOPE 2. REFERENCES 2. DEFINITIONS AND TERMINOLOGY 2. GENERAL 2. INTRODUCTION 2. PREDICTIVE MAINTENANCE SCHEDULE FOR CENTRIFUGAL PUMPS 3. PREVENTIVE MAINTENANCE INSPECTION SCHEDULE FOR. CENTRIFUGAL PUMPS 3. Horizontal Centrifugal Pumps (Both ends supported) 3. Horizontal Centrifugal Pumps (Overhanging Type) 5. Submersible Pumps (Wet Motor Type & Dry Motor Type) 6. Vertical Centrifugal Pumps 7. Partwise Inspection during complete Overhaul of Centrifugal Pumps 8. Commissioning and Testing Procedures for Centrifugal Pumps 12. PREVENTIVE MAINTENANCE INSPECTION SCHEDULE FOR POSITIVE. DISPLACEMENT PUMPS 15. Reciprocating/ Plunger/ Diaphragm Pumps 15. Gear Pumps/ Screw Pumps 17.
washer found damaged and lock nut loose, shaft axial play shall be checked). iv. Inspection of bearings (replace the bearings if necessary). v. Pump float (adjust if necessary) vi. Oil filter for cleanliness if journal bearings are hydrodynamic vii. Inspect condition of mechanical seals viii. Alignment (Misalignment shall not be more than 0.05 ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: