Transcription of SPLICES, DEVELOPMENT AND STANDARD HOOKS FOR …
{{id}} {{{paragraph}}}
Example: bankruptcy
SPLICES, DEVELOPMENT AND STANDARD HOOKS FOR …
An information series from the national authority on concrete masonry technologyNCMA TEK 12-6 1 splices , DEVELOPMENT AND STANDARD HOOKS FOR CONCRETE MASONRYTEK 12-6 Reinforcement & Connectors (2007)INTRODUCTION Building codes include requirements for minimum rein-forcement DEVELOPMENT lengths and splice lengths, as well as requirements for STANDARD HOOKS , to ensure the adequate transfer of stresses between the reinforcement and the masonry. This TEK presents these requirements, based on the provisions of both the 2003 and 2006 editions of the International Building Code (IBC) (refs.)
2 NCMA TEK 12-6 butted or shortly lapped and welded to develop in tension at least 125% of the specified yield strength of the bar. All weld-ing is required to conform to AWS D 1.4 (ref. 6).
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
U-FACTORS OF SINGLE WYTHE TEK 6, TEK 6, CONTROL JOINTS FOR CONCRETE MASONRY, Technical Data Sheet, 55D MT, TDR Impedance Measurements: A Foundation for, Iberville Commercial Grade Fittings, Iberville ® Commercial Grade Fittings, FIRE RESISTANCE RATINGS OF CONCRETE MASONRY TEK, FIRE RESISTANCE RATINGS OF CONCRETE MASONRY