Commentary for Acceptable Solutions ... - Building Performance

Building work that does not require a building consent

GUIDANCE Building Act 2004 THIRD EDITION 2014 - AMENDED AUGUST 2017 Building work that does not require a building consent

  Guidance

C/AS2 - Acceptable Solution for Acceptable Solution for ...

C/AS2 Acceptable Solution for Buildings with Sleeping (non institutional) (Risk Group SM) For New Zealand Building Code Clauses C1-C6 Protection from Fire

Earthquake geotechnical engineering practice

Earthquake geotechnical engineering is a highly specialised field. As such the investigations for this need to be developed and carried out by an appropriately qualified and experienced geotechnical engineer or engineering geologist (referred to herein as the geotechnical professional). For the purposes of this document ‘geotechnical

  Geotechnical

E2 External Moisture

For single- and two-storey concrete and concrete masonry construction within specific limitations: E2/AS3. For light steel framed buildings up to 3 storeys, within specific limitations: E2/AS4. E2.3.3 Ground contact or proximity All walls, floors and structural elements in ground contact or proximity, except for buildings where external

  Light, Concrete

Module 6: Earthquake resistant retaining wall design

guidance on earthquake design aspects for retaining . structures that are not well covered in these handbooks or elsewhere. The main objective is to identify situations where seismic design of retaining structures should be considered, to provide the necessary seismic parameters, and to identify key issues relating to seismic design.

  Design, Seismic, Structure, Walls, Module, Resistant, Seismic design, Retaining, Earthquake, Module 6, Retaining structures, Earthquake resistant retaining wall design

Worked Example 4 | Design of a tied-back retaining wall to ...

Design of a tied-back retaining wall to resist earthquake loading . Worked example to accompany MBIE Guidance on the seismic design of retaining structures for residential sites in Greater Christchurch (Version 2) November 2014 . Tied-back retaining walls were used originally as a substitute for braced retaining walls in deep excavations.

  Design, Seismic, Structure, Walls, Loading, Seismic design, Retaining, Earthquake, Sisters, Retaining structures, Retaining wall to resist earthquake loading

Acceptable Solutions and Verification Methods

4.2 Sizing of downpipes 42 4.3 Installation of downpipes 42 5.0 Roof Gutters 42 5.1 Size of roof gutter 42 5.2 Materials44 5.3 Gradients44 5.4 Thermal movement 44 5.5 Overflow outlets 44 Appendix A Rainfall intensities 45 Index 47 Contents Amend 4 Dec 2000 Amend 4 …

  Verification, Solutions, Methods, Acceptable, Roof, Appendix, Sizing, Acceptable solutions and verification methods

Acceptable Solutions and Verification Methods

4.2 Sizing of downpipes 42 4.3 Installation of downpipes 42 5.0 Roof Gutters 42 5.1 Size of roof gutter 42 5.2 Materials44 5.3 Gradients44 5.4 Thermal movement 44 5.5 Overflow outlets 44 E1/AS1 Appendix A Rainfall intensities 45 Acceptable Solution E1/AS2 52 1.0 AS/NZS 3500.3 Stormwater Dec 2000 drainage52 Index 56 Contents Amend 4

  Verification, Solutions, Methods, Acceptable, Roof, Appendix, Sizing, Acceptable solutions and verification methods

Constructing Cavities - Building Performance

Table 23 (’Properties of roof underlays and building wraps‘). Install the wall underlay directly over the framing. Install the cavity battens directly over the wall underlay as described in Cavity battens on page 9. No additional wall underlay is needed between the wall cladding and the cavity battens except in the following situations.

  Building, Constructing, Wrap, Cavities, Building wraps, Constructing cavities

Earthquake geotechnical engineering practice

2 Site and liquefaction considerations 2.1 Site characterisation One of the initial steps in the design of ground improvement is to develop a geotechnical model for the site which fits within the wider regional geology and geomorphology. This starts from review of …

  Practices, Site, Characterisation, Site characterisation

1 RULES OF STATE DEPARTMENT OF TRANSPORTATION - …

for Houses. 672-2-.09 Revocation, Suspension of, Denial for Application or Renewal of Permits. Amended 672-2- ... A residential or commercial dwelling or building transportable in one or more sections, which in the traveling mode has a box width of eight (8) feet or more and a ... secondary tandem axle exceeds 28,000 pounds; or (C) Whose total ...

  House, Secondary, Dwelling

RS-1 District Schedule - Vancouver

(b) for two-family dwelling or two-family dwelling with secondary suite, 10.7 m and 2 ½ storeys. 4.3.2 The secondary envelope need not be less than 9.8 m in width except as limited by the required side yard. 4.3.3 Height shall be measured from a hypothetical surface determined by joining the existing grades

  Secondary, Dwelling

CHAPTER 2.1 DWELLING HOUSES, SECONDARY …

Chapter 2.1 Dwelling Houses, Secondary Dwellings and Ancillary Development Wyong Development Control Plan 2013 Page 6 3.0 SETBACKS A building line or setback is the shortest horizontal distance between the property boundary or other stated boundary (measured at 90 degrees from the boundary) and: a building wall, or ...

  Development, House, Secondary, Dwelling, Ancillary, Dwelling houses, Secondary dwellings and ancillary development

RS-5 District Schedule - Vancouver

family dwelling, or two-family dwelling with secondary suite, is 7.3 m. 4.1.2 Where the site is less than 9.8 m in width or less than 334 m² in area, the design of any new dwelling shall first require the approval of the Director of Planning.

  Secondary, Dwelling

Short Term Rental Accommodation (STRA)

Secondary dwellings above a garage – in single dwelling houses (Class 1a buildings) • An inter-connected heat alarm in the garage To clarify: a heat alarm is required where there is an approved secondary dwelling such as a ‘Fonzie flat’ or studio above the garage of the main dwelling. A standalone dwelling with a garage does not require a

  House, Secondary, Dwelling, Dwelling houses, Secondary dwelling