INSTALLATION - Huber Engineered Woods
wood fiber cement, wood and cedar shakes, traditional hard coat stucco and EIFS* applications. Approved roof coverings include asphalt-fiberglass shingles, metal tiles and panels, clay and concrete tiles, slate and slate- type shingles and wood shakes and shingles. Follow all cladding and roof covering manufacturer’s installation instructions.
Download INSTALLATION - Huber Engineered Woods
Information
Domain:
Source:
Link to this page:
Documents from same domain
ZIP System R Sheathing - Huber Engineered Woods
www.huberwood.comZIP System R Sheathing Installation 04 ZIP System ® R Sheathing Installation Manual Step 3. Fasten the panels to the framing members with code approved fasteners. When used to resist lateral
0 ICC ES Report ESR - Huber Engineered Woods
www.huberwood.comICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed , nor are they to be construed
Installation Instructions - Huber Engineered Woods
www.huberwood.comInstallation Instructions ComposItIon & materIals Huber Engineered Woods (HEW) is committed to the responsible use of natural resources. AdvanTech® panels are produced from young, fast- growing trees for less waste and faster availability.
ADVANTECH® SHEATHING
www.huberwood.comliterature, test reports, installation instructions, and special applications are available through Huber Engineered Woods. Please visit advantechperforms.com or call 800.933.9220 xt E 2716 to speak to a technical representative.
Installation Manual-ZIP System Sheathing-Wall and Roof
www.huberwood.companels in applications where the wall sheathing is designed to resist combined wind uplift and shear. Do not use in fire-rated assemblies in lieu of a ... framing1, light gauge metal framing2, CMU/concrete walls3 and new or existing OSB and plywood sheathing4. 1: Follow installation requirements in ESR-3373 and the remainder of this report. ...
Contents
www.huberwood.comlaminated with a water-resistive facer on the exterior and a rigid foam insulation panel bonded on the opposite (interior) face. When properly installed andtaped, ZIP System - R-Sheathing provides a water-resistive barrier, air barrier and exterior insulation in one product. It may also be
Related documents
Fiberglass Exterior Doors - Feather River
www.featherriverdoor.comThere are many reasons why over a million of our doors are in homes just like yours. Our Feather River Fiberglass Door System is a marriage of low maintenance fiberglass with timeless warmth of woodgrain patterns. Add our handcrafted glass and it becomes a piece of art. Our doors are superior in craftsmanship, security, style and functionality.
Technical Guide: DensGlass® Sheathing
floridabuilding.orgThe framing width shall not be less than 1-1/2” (38 mm) wide for wood framing and 1-1/4” (32 mm) for steel framing. Framing members shall not vary more than 1/8” (3 mm) from the plane of the faces of adjacent framing. • Fasteners should be driven flush with the panel surface (not countersunk) and into the framing system. Locate fasteners at
Butternut HF6V - DX Engineering
static.dxengineering.comThere may be fiberglass dust, slivers or particles present when the fiberglass parts were manufactured. The use of typical fiberglass handling safety gear (gloves, dust mask, eye shield, clothing, etc.) when handling and working with fiberglass is recommended. Use a damp rag to wipe the parts. Do not use compressed air to clean fiberglass parts ...
Curbless Showers - NCSU
projects.ncsu.eduis not necessarily more expensive than an equiva-lent prefabricated unit. However custom units do require more careful detailing and good super-vision during construction. The following sections discuss how the floor construction (either rein-forced concrete slab or wood joist framing) and the shower unit type influence “no-threshold”
Insulation Guide: California Title 24, 2020 - Johns Manville
www.jm.comClimate Zones 1-5 and 8-16 Wall assemblies must not exceed a maximum U-factor ... Stucco Over R-4 EPS Foam Board 2x4 16” o.c. R-15 JM Fiberglass or Mineral Wool 0.065 ... is a building method that maximizes the insulated portion of the wall and eliminates redundant or unnecessary wood components. Title 24 defines the requirements for AWS in ...
Building nsulation Submittal Form - Johns Manville
www.jm.comfor concealed metal and wood-framed wall and ceiling applications, directly above suspended ceiling systems and under floors. Poly-encapsulation makes installation cleaner and acts as a vapor retarder. ComfortTherm Poly- encapsulated Batts are also available with a vapor-retarder facing, recommended for hot, humid climates and over existing
19031104 Polyglass SBS Mod Bit SA over Wood
www.miamidade.govSelf-adhered, fiberglass reinforced, SBS modified bitumen membrane with a self-adhering back face and a smooth top surface. Elastoflex SA V FR 66’ 8” x 3’ 3-3/8” ASTM D 6163, Type I Self-adhered, fire-rated, fiberglass reinforced, SBS modified bitumen membrane with a self-adhering back face and a smooth top surface. Elastoflex SA V PLUS
MOLDED FIBERGLASS GRATING - Strongwell
www.strongwell.comDURATREAD™ molded fiberglass stair tread covers provide an easy, cost-effective way to increase the safety of stairways. The covers are intended for installation over concrete, metal or wood steps. Fiberglass stair treads may also be covered with DURATREAD ™ covers. DURATREAD™ stair tread covers are ideal for use in any