IQ Range - Rotork
Actuator selection for linear valve types: Wedge, Conduit / slab, Parallel slide, Globe, Choke, Knife, Sluice / weir, Diaphragm. Direct ISO5210 MSS SP-102 IQ (3-Phase) Min Max IQS (1-Phase) Min Max IQD (DC) Min Max IQM (3-Phase) Min Max Torque Nm 14 3,000 26 450 14 305 14 544 lbf.ft 10 2,200 19 332 10 225 10 400 Thrust
Download IQ Range - Rotork
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Advertisement
Documents from same domain
CP Range - rotork.com
www.rotork.comUS A4 US A4 US A4 US A4 A4 US US A4 US A4 A4 US Redefining low Control 5 30 14 26, 27, 28 31 7 30 14 4 1 18A 2, 3 19 15 23 * Quantity (2) for double-acting, (3) …
Solenoid Valves - Rotork
www.rotork.comRotork is committed to providing first class support to each client throughout the whole life of their plant, from initial site surveys to installation, maintenance, audits and repair. From our network of national and international offices, our engineers work around the clock to maintain our position of trust. Rotork. Keeping the world flowing.
IQ Range Installation and Maintenance Instructions
www.rotork.comThe on board Datalogger captures operational and valve torque data enabling informed maintenance choices to be made. IQ Insight software for PC and PDA allows the Datalogger to be interrogated, as well as the complete actuator set up to be configured and recorded. The actuator containing the Setting Tool will be identified with a yellow
ROTORK RANGE
www.rotork.comof the Rotork IQ Range actuator be required, this will be provided on request. Health and Safety 1 2 WARNING: With respect to the handwheel operation of Rotork electric actuators, under no circumstances should any additional leaver device such as a wheel-key or wrench be applied to the handwheel or in order to develop more force
RC200 Pneumatic Actuators - Rotork
www.rotork.com1 Nm = 0,102 kpm = 8,85 Ib.in. 1 kpm = 9,81 Nm = 86,8 Ib.in. 1 Ib.in = 0,113 Nm = 0,0115 kpm Pressure 1 Mpa = 10 bar = 10,2 kp/cm² = 145 psi 4 Size Torque in Nm. Air pressure 0,6 Mpa (6 bar / 87 psi) Air opens Spring closes 7400 3570 5400 15250 7200 11350 3800 1900 2740 7600 3800 5480 1296 609 921 1890 940 1360 450 225 320 910 460 650 145 72 ...
Piston Actuated Valves Catalogue
www.rotork.com6 Piston Actuated Valves Catalogue USA4 US A4 US A4 US A4 A4 US A4 US A4 A4 US Valve Selection Piston actuated valves use an external control medium to pilot the actuator, where a piston is directly connected to the main seal that closes onto the main orifice, thereby controlling the flow of liquids and gases.
IQT Range - Rotork
www.rotork.comfor more information on the IQ, Insight2 and other Rotork actuator ranges. 2. Health and Safety This manual is produced to enable a competent user to install, operate, adjust and inspect Rotork IQT range valve actuators. Only persons competent by virtue of their training or experience should install, maintain and repair Rotork actuators. Under ...
CP Spring Return Series Actuators
www.rotork.comCP Spring Return Series Actuators Dimension Data (metric) Date 16/05/2018 Revision 0. Spring return (drawing) 2 of 13. CP Series SPRING RETURN, PNEUMATIC ACTUATOR - Dimensional Data 3 of 13 CP/S-035-080*/AA F07 589 167 422 112 43 71,5 35 116,5 51,5 19 6,5 98,5 27 24 22 16 60 60 100 49,5 M8 10,5 13 49,25 100 5 80 80 40 M10 10 13 0,5 1/4" 16 141 ...
Series, Return, Pneumatic, Spring, Actuator, Spring return, Cp spring return series actuators
IQ Range - Rotork
www.rotork.comUninterruptible power supplies ... PUB002-021 IQ single-phase power supply rating data. IQD – DC power supplies IQD10, IQD12, IQD20 and IQD25 are available for standard nominal voltages: 24 V*, 48 V*, 110 VDC ... special high torque low inertia design. 15 minute rated with
Power, Supply, Power supply, Uninterruptible, Uninterruptible power
IQ Range - Rotork
www.rotork.com1.3 Introduction to this manual This manual provides instruction on: • Manual and electrical (local and remote) operation. • Preparation and installation of the actuator onto the valve. • Basic commissioning. • Maintenance. Refer to Publication PUB002-047 for repair, overhaul and spare part instructions. Refer to Publication PUB002-040
Related documents
STANDARD SPECIFICATIONS FOR ROADS AND STRUCTURES - …
connect.ncdot.govnorth carolina department of transportation raleigh standard specifications for roads and structures january 2018
WATER & SANITATION DEPARTMENT - Cape Town
resource.capetown.gov.zaService Guidelines & Standards for Water and Sanitation Department CCT 2 DISCLAIMER It is expected that any developer/engineer should utilise the city’s infrastructure design
ANSI Chart Cast and Ductile Iron Flange Chart Dimensions ...
globalsupplyline.com.auIt should be noted that some soft seated valves such as knife gate, rubber lined butterfl y or sluice gate valves may have a lower maximum working pressure than the fl ange is rated at. ... down rate the valve pressure rating despite what fl anging the valve may be supplied with. GLOBAL SUPPLY LINE Table 1. Nonshock pressure ratings of gray ...
Water Corporation water symbols glossary (PDF 202KB)
www.watercorporation.com.auValve 8 Fully operational valves 9 Close directions 9 Zone Isolation Valves 9 Non Control Valves 10 Operation Codes 10 Asset Boundaries 10 ... REG Regulating valve RV Reflux valve SV Sluice valve . Fully operational valves. will show as: Open Text Displayed Closed If . Type. is - ALT, BRONZE, BV, FW, MBV, R or SV . If .
BUREAU OF INDIAN STANDARDS List of IS No. Covered ... - …
ficci.in96is 909 : 1992 ced 22underground fire hydrant, sluice valve type 1 97is 915 : 1975 chd 12one-mark volumetric flasks 1 98is 916 : 2000 mtd 32square tins for solid products - 7 99is 928 : 1984 ced 22fire bells 2 100is 940 : 2003 ced 22portable fire extinguisher, water type (gas cartridge) - 48 single phase a.c. induction motors 139
Wastewater Symbols - Water Corporation
www.watercorporation.com.auThe size of the valve is stored in the GIS, but not displayed. ... Scour Non-control Valve Gate Valve Control Valve Reflux Valve Control Valve : Sluice Valve .
Wastewater, Valves, Symbols, Celsius, Wastewater symbols, Sluice valve
Design of Mechanical Hydraulic Jack - IOSR-JEN
iosrjen.orgChina conveyed water along channels for irrigation and domestic purposes, using dams and sluice gates to control the flow. The ancient Cretans had an elaborate plumbing system. Archimedes studied the laws of floating and submerged bodies. ... The ram cylinder connected to delivery valve of plunger cylinder. It is also consists of lowering screw ...
IS 13039 (1991): External hydrant systems - provision and ...
law.resource.orgValve wheels should have an arrow head engraved or cast thereon showing direction for turning ‘open’ and ‘close’, 5.7 The mains should not be laid under build- ings, large open storages, railway lines and roads ... sluice valves should be provided at the points of entry and exit. 5.8 The mains should be laid according to the ...
Abbreviations - wsd.gov.hk
www.wsd.gov.hkButterfly valve Bottom vertical bend : CSK Countersunk : D.A.V. Double air valve : D.M.M. DN or dn District metering meter Nominal diameter : NS or ns F.H. F.M.C. Nominal size of PE pipe Fire hydrant Flow measurement chamber : WSD Standard Drawings - Abbreviations Page 1 of 5 : Updated :6/1/2016