SSI Synchronous Serial Interface Master - Application Note
APPLICATION NOTE 2013-11-08 6/26 Art.No. 10021488 1. SSI Theory Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications especially, rotary encoders. It is a point-to-point connection from a master (e.g. PLC, microcontroller or other control systems) to a slave (e.g. the rotary encoder).
Download SSI Synchronous Serial Interface Master - Application Note
Information
Domain:
Source:
Link to this page:
Related documents
Application Note Slave Controller - Beckhoff Automation
download.beckhoff.comSlave Controller – Application Note PHY Selection Guide 1 1 Overview An EtherCAT Slave Controller (ESC) takes care of the EtherCAT communication as an interface between the EtherCAT fieldbus (Ethernet) and the slave application. EtherCAT uses 100Mbit/s full duplex Ethernet communication. EtherCAT G uses 1,000Mbit/s full duplex
Interfacing to High Speed ADCs via SPI - Analog Devices
www.analog.comThis application note describes how to use the serial peripheral interface ( SPI) port on Analog Devices, Inc., high speed converters . In addition, this application note defines the electrical, timing, and procedural requirements for interfacing to these devices. The implementation is compatible with industry -standard SPI
MPC5121e Serial Peripheral Interface (SPI)
www.nxp.comThe purpose of this application note is to describe the serial peripheral interface bus controller (SPI) implemented on Freescale’s MPC5121e microcontroller. It describes how to config ure and use the programmable serial controller (PSC) and PSC centralized FIFO controller (FIFOC) in all supported SPI modes. 1.1 Objective
SMBus Quick Start Guide - NXP
www.nxp.com• A slave is a device that receives or responds to a command. A system may not include a host. For example, a simple battery charging system is a hostless system. In an SMBus system, a device can be master only, slave only, or it may act as a slave most of the time, but in special instances it becomes a master. Table 3. Reserved SMBus addresses 1
AN4776 Application note - STMicroelectronics
www.st.comApplication note General-purpose timer cookbook for STM32 microcontrollers Introduction The timer peripheral is part of the essential set of peripherals embedded in all the STM32 microcontrollers. The number of timer peripherals and their respective features differ from ... The master/slave controller unit of the slave timer is configured to ...
SPI Configuration and Flash Programming in UltraScale ...
www.xilinx.comapplication note, SPI operates in a full duplex mode sending commands and addresses from the master over the master-output, slave-input (MOSI) line and receiving data over the master-input, slave-output (MISO) line. Data is synchronous with an SPI clock (SCLK) signal, and the slave device is selected via an SPI select (SS#) signal.