3 Compressed Water And Superheated Steam
Found 7 free book(s)Table 3. Compressed Water and Superheated Steam
www.nist.gov17 Table 3. Compressed Water and Superheated Steam (continued) 0.01 MPa (ts = 45.806 °C) 0.02 MPa (t s = 60.058 °C) 0.03 MPa (t s = 69.095 °C) v ρh s t, °C v h s t, °C v ρ h s 26 446. 0.037 814 3076.7 9.2827 300 13 220. 0.075 645 3076.5 8.9625 300 8811.0 0.113 49 …
PROPERTY TABLES AND CHARTS (SI UNITS)
homepages.wmich.eduTable A–3 Properties of common liquids, solids, and foods Table A–4 Saturated water—Temperature table Table A–5 Saturated water—Pressure table Table A–6 Superheated water Table A–7 Compressed liquid water Table A–8 Saturated ice–water vapor Figure A–9 T-s diagram for water Figure A–10 Mollier diagram for water
Steam Sterilization Principles - ISPE
www.ispe.gr.jpSuperheated steam, steam containing excessive liquid water, and steam containing excessive boiler additives or contami-nates (such as rust) should be avoided. Superheated steam ... phase or unloading process as seen in Figure 3. Clean, dry compressed air (process air) is …
SOLUTIONS: HOMEWORK #6
civil.colorado.eduSubstituting, the mass flow rate of cold water stream is determined to be () ()= 0.864 kg/s − − = 0.5 kg/s 175.92 83.96 kJ/kg 334.91 175.92 kJ/kg m&2 5-106 Feedwater is heated in a chamber by mixing it with superheated steam. If the mixture is saturated liquid, the ratio of the mass flow rates of the feedwater and the superheated vapor is ...
Chapter 7 Vapor and Gas Power Systems - CPP
www.cpp.eduIf the steam enters as a superheated vapor, it does not condense significantly in the turbine. If the steam is saturated as it enters the turbine, a significant of liquid is formed which causes erosion and wear of the turbine blades. Process 2-3: The steam enters the condenser and exits in state 3 as saturated liquid water.
(Pressure of Saturated Liquid in a Tank)
uowa.edu.iqExample 12–6 / Determine the temperature of water at a state of P = 0.5 MPa and h = 2890 kJ/kg. Solution: The temperature of water at a specified state is to be determined. Analysis: At 0.5 MPa, the enthalpy of saturated water vapor is hg = 2748.1 kJ/kg. Since h > h g, as shown in ( Fig. 12- 6 ) , we again have superheated vapor. Under
CANKAYA UNIVERSITY FACULTY OF ENGINEERING AND …
me213.cankaya.edu.tr2) A rigid tank with a volume of 2.5 m3 contains 5 kg of saturated liquid-vapor mixture of water at 75oC. Now the water is slowly heated. Determine the quality x at the initial state. Also, determine the temperature at which the liquid in the tank is completely vaporized. v = constant 0.5 m / kg 5 kg 2.5 m m V v 3 3 1 T 1 = 75 oC From Table A-2 ...