V 51 Incandescent
Found 9 free book(s)V-51 Incandescent Luminaires Enclosed and Gasketed
www.emerson.comV-51™ Incandescent Luminaires Enclosed and Gasketed UNILETS® for use with threaded metal conduit. Fixtures suitable for use in wet locations. NEC: Class I ...
Diva C L Dimmer - lutron.com
www.lutron.comSPECIFICA AL Page ob Name ob Number Model Numbers 369682b 1 11.14.17 Diva C •L Wb ols Diva C•L Dimmer Dimmer for CFL, LED, Halogen, and Incandescent dimmable bulbs.
250 W C L Dimmer - Lutron Electronics
www.lutron.comSPECIFICA AL a ob Name ob Number Model Numbers 369810a 1 04.08.14 a ® 250 • L ® Wa ols Diva ® 250 W C•L ® Dimmer Dimmer for CFL, LED, Halogen, and Incandescent dimmable bulbs. Features
Analog Current Output Type Ambient Light Sensor IC - Rohm
rohmfs.rohm.com1/8 © 2012 ROHM Co., Ltd. All rights reserved. www.rohm.com 2012.02 - Rev.D Ambient Light Sensor ICs Analog Current Output Type Ambient Light Sensor IC BH1603FVC
V-Series - Carling Tech
www.carlingtech.comV-Series Switch Carling Technologies, Inc. 60 Johnson Avenue • Plainville, CT 06062-1177 Phone: (860) 793-9281 • Fax: (860) 793-9231 Email: sales@carlingtech.com • www.carlingtech.com
NEW PRODUCTS 2014 - Legrand
www.legrand.com.sg321 British standard wiring accessories BelankotM synergytM MalliatM complete white BelankotM RJ 11 + RJ 45 socket (p. 325) NEW PRODUCTS 2014 P. 323 Switches and push-buttons
Voltage Backfeed on Distribution Lines - swedeus.org
www.swedeus.org4 Distribution Circuit Configuration This is a typical distribution circuit in an urban setting where both a commercial strip center and a residential subdivision are served from the same three-phase
SWITCHRITE arteor catalog
www.switchrite.co.za62 Arteor TM mechanical switches - square version Support frames and plates selection chart (p. 100 to 107) Pack Cat.Nos Switches 10 AX - 250 V A Single module mechanisms 1 module of 22.5 x 45 mm
LP395 Ultra Reliable Power Transistor datasheet (Rev. C)
www.ti.comLP395 SNOSBF3C – APRIL 1998– REVISED MARCH 2013 www.ti.com These devices have limited built-inESD protection. The leads should be shorted together or the device placed in conductive foam