Combination Fire Smoke Damper Steel 3V Blades UL 555 1 ...
Fire Damper Listing (#3225-0981:103) Leakage (Smoke) Damper Listing (#3230-0981:104) Model FSD-211 Combination Fire Smoke Damper Steel 3V Blades UL 555S Leakage Class I UL 555 11⁄ 2 Hour Fire Resistance Rating Application Model FSD-211 is a combination fire smoke damper with 3V style blades. This model is designed for operation and dynamic ...
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
Centrifugal Ceiling Exhaust and Inline Cabinet Fans
content.greenheck.com3 Model Comparison Model Location Mounting Airflow Application Drive Type Impeller Type Performance Outdoor Indoor Roof Curb Base/Floor Hanging Wall Ceiling Mounted Exhaust Supply Reversible Recirculate General/Clean Air Contaminated Air Spark Resistant Grease (UL 762) Smoke Control (UL) High Wind (150 mph) High Temp (above 200°F ) Belt Direct Centrifugal Propeller/Axial …
Indirect Gas-Fired Make-Up Air - content.greenheck.com
content.greenheck.com5 Controls Discharge Temperature Control In make-up air units, the unit-controlled heat output is based on discharge temperature. A factory-mounted
Minimum 180 in-lb Torque Applications
content.greenheck.comFor damper areas up to 45 sq-ft*(For lower torque, see AF, NFB, LF, ... Time to fit your Specific Application with Belimo’s Flexible Line of ... done in accordance with the damper manufacturer’s specifications. Control is On/Off from an auxiliary contact, or a manual switch. ...
Modular Make-Up Air Unit - content.greenheck.com
content.greenheck.comModular Make-Up Air Unit Model MSX Commercial, Industrial, and Kitchen Applications ... supply air for general, process and combustion exhaust. ... • Airflow Arrangement - Optional Variable Air Volume or Constant Volume 100% Outdoor Air • Performance Range - 800 to 7,500 cfm ...
Heating and Ventilating Units - content.greenheck.com
content.greenheck.com2 Heating Options Hot water, steam and electric heat options are available. The heating section consists of a factory-installed heating coil in a pre-engineered housing.
Energy Recovery and Make-Up Air Start-Up Report
content.greenheck.com5 Condenser Airflow S 6 6 4 8 5 3 4 12 4 1 2 14 13 11 10 9 Supply Airflow P1 P2 T1 T2 Packaged DX Cooling with Digital Scroll Compressor Water-Source Heat Pump with Standard Scroll Compressor
High Performance Vane Axial Fans - content.greenheck.com
content.greenheck.comfi 2 Model RA High Performance Vane Axial Fans RA high performance, direct-driven vane axial fans are ideal for inline air ventilation in commercial, institutional or industrial buildings.
Installation, Operation and Maintenance Manual
content.greenheck.com2 Ceiling Exhaust and Inline Fans ® Typical Installation The ducting from this fan to the outside of the building has a strong effect on the air flow, noise and energy use of
FumeJet Exhaust Systems - content.greenheck.com
content.greenheck.com2 Greenheck’s FumeJet® line of exhaust fans with integral stacks are designed to safely remove and disperse fumes and odors. FumeJet systems replace utility set fans with field supplied intake
Installation, Operation and Maintenance Manual
content.greenheck.comUpblast Centrifugal Roof Exhaust 3 ® When lifting a Belt Drive unit onto the roof, use either the four lifting points on the drive frame or the two lifting
Related documents
Par t C Fire Resisting Construction - Buildings Department
www.bd.gov.hkSmoke seal is very effective in preventing the spread of smoke through a fire rated door. A tight-fitting and latched fire rated door does not prevent smoke spread. Smoke seals should be provided to the top and sides of the fire rated door. 82 Subsection C7 - …
Seal, Construction, Fire, Smoke, Resisting, Moses lake, T c fire resisting construction
How to ensure ‘Certifire’ Fire Door Certification is ...
firedoors.bwf.org.uk8. You can produce a FD30S or F60S ‘smoke control door’ but it MUST be fitted with the correct CE marked and Certifire Approved smoke seals. Please check the CF for the SEAL to confirm that it can be used. Take note of the threshold gaps required for smoke doors. 9.
DURATION ® HARMONY ® SUPERPAINT OPULENCE - …
images.sherwin-williams.com•Seals in odours from fire, smoke, and pets. •Seals in stains and graffiti Primes and seals in one coat. PRIME RX PEEL BONDING PRIMER •Seals surfaces and assures a smoother finish. •Saves time, money and labour with less sanding and scraping. •Goes on milky-white for ease of application and dries clear.
ADVICE NOTE FIRE SAFETY IN FLATS - ARMA
arma.org.ukA fire door set can only offer protection in limiting the spread of smoke and fire if the door seals are working effectively and if the door can fully close into the recess under the action of its door closer. The self-closing device should be capable of closing the door securely into its frame from
NFPA Code Requirements
assets.new.siemens.comSafety seals, tags, pressure gauge readings, HMIS Label. Fire Pumps NFPA 25 Weekly system procedures. Electric 10 min. Diesel 30 min. Alarm Systems NFPA 72, ... Fire Phones Heat Detectors All Smoke Detectors - Functional Fire - Gas and other detectors Interface Equipment Special Hazard Equipment Alarm Notification Devices
FIRE SAFETY LOG BOOK - irp-cdn.multiscreensite.com
irp-cdn.multiscreensite.comsmoke should be inspected to ensure that the fire and smoke resistance is being maintained i.e. no holes in walls and floors, no broken glazing, doors are not damaged and smoke seals touch the door and frame continuously, etc.
Seal, Fire, Smoke, Moses lake
Fire Doors Basic Guidance & Checklist - London Borough of ...
www.merton.gov.ukIntumescent fire and smoke seals For a door to work effectively, the door leaf must be free to move within the frame. In order to do this there must be a gap around the perimeter which may compromise the door’s ability to restrict the spread of fire. Intumescent seals are the strips set into the door or frame that swell up
Seal, Fire, Smoke, Moses lake
Fire and Life Safety Guidelines for Schools
esa.dc.govAll portable fire extinguishers must be checked monthly for obvious damage, broken seals, and to ensure that the gauge is in the operable range or, if not equipped with a gauge, for the proper weight. School-based personnel are responsible for monthly inspection of fire extinguishers. •