Densglass Shaftliner Area Walls Technical Guide
C-Track at one end of the area separation wall. Install the H-stud into the C-track and over the double beveled edges of the shaftliner panels and continue alternately until the wall has reached the opposite end of the foundation. Terminate the wall using a C-Track. The
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
Technical Service Hotline 1.800.225.6119 or www.gpgypsum
www.buildgp.comassembly installation instructions). Primary Uses Because of the superior performance of DensGlass Sheathing, it is specified for exterior walls, ceilings and soffits in a wide variety of applications. These include exterior insulation and finish systems (EIFS); cavity brick or stone veneer applications;
Services, Installation, Technical, Instructions, Installation instructions, 1961, Hotline, Technical service hotline 1, 6119 or
TECHNICAL GUIDE - Georgia-Pacific Building Products
www.buildgp.cominstallation. DensGlass Sheathing is the ideal substrate for a wide variety of air and water-resistive barriers including building wraps, fluid applied coatings, self-adhering membranes and spray foam applications. See page 10 for details. Easy to Handle DensGlass Sheathing is lightweight and easy to handle.
Guide, Product, Technical, Pacific, Building, Georgia, Wrap, Technical guide, Building wraps, Georgia pacific building products
SHAFTLINER FOR SHAFTWALL/STAIRWELL SYSTEMS
www.buildgp.comNote that the edges of the panel are beveled to help guide the panel into the slotted and tabbed section of the stud. 6. Progressively install succeeding studs and panels as described above until the wall section is enclosed. The final panel section may be secured with 1-5/8” (41 mm) Type S screws or tabs from the J track at 24” (610 mm) o ...
TECHNICAL GUIDE - Gypsum, Wood, Lumber, OSB Boards
www.buildgp.comDec 01, 2017 · The unique construction has been shown to withstand delamination, deterioration, warping and job site damage far more effectively than paper-faced gypsum board and other conventional roofing products such as wood fiberboard and perlite. • Provides superior fire protection. • Resists fire and hail damage.
Technical Guide: DensArmor Plus® High-Performance Interior ...
www.buildgp.comof Gypsum Panel Products” and ASTM C840 “Standard Specifi cation for Application and Finishing of Gypsum Board for Non-Fire Rated Construction.” For best results, abut DensArmor Plus panels against regular paper-faced drywall only at inside or outside
Stamps/Signatures
www.buildgp.comFIRE SAFETY CAUTION Passing a fire test in a controlled laboratory setting and/or certifying or labeling a product as having a one-hour, two-hour, or any other fire resistance or protection rating and, therefore, as acceptable for use in certain …
DensShield® Tile Backer Installation Instructions
www.buildgp.comDS001. Note: Shower pan or rubber membrane must be adequately sloped to the open drain or weep hole detail to permit proper water drainage. Leave a 1⁄89 (3 mm) gap between DensShield Tile Backer and the shower pan. • DensShield Tile Backer is not to be used in shower curbs. • DensShield Tile Backer panels can be installed in the shower
Technical Service Hotline 1.800.225.6119 or www.densdeck
www.buildgp.commanufacturer’s specifications for full mopping applications and temperature requirements. ... * Testing was done in accordance with FM approvals 4470, Appendix C: Small Scale Tests, Membrane ... with the ANSI/UL 1256 Steiner Tunnel test. For additional information concerning
Tests, Scale, Tunnel, Full, Cast steel
Related documents
DESIGN AND ANALYSIS OF RETAINING WALLS
www.ced.ceng.tu.edu.iq(g) Sheet pile walls are classified as; anchored and cantilevered sheet pile walls; each kind of them may be used in single or double sheet walls. Of these walls, only the cantilever retaining walls and the bridge abutments are mostly used at present due to their great economics. 8.3 DESIGN CONSIDERATIONS 8.3.1 Definitions of Terms
Construction Guide: Energy Efficient, Durable Walls
www.energy.govHigh Performance Walls || CZ 3-5 15 INSULATED DOUBLE HEADER 2.5-3" of insulation: R13-19 (rigid foam) Most openings in a house Prefabricated or site-built Must be capped, if foam sandwiched between the double members 2X6 WALLS - FRAMING AT OPENINGS
Determination of Earth Pressures on Retaining Walls
web.mst.eduThe walls of the excavation are pervious enough so that water pressure does not build up behind them; and 3. The lateral movements of the walls are kept below 1% to 2% of the depth of the ... The build-up of pore water behind a retaining wall can roughly double the active force on such a structure from that imposed by a dry backfill. It is ...
Acoustic and Fire Assemblies - CertainTeed
www.certainteed.comDouble Wood Stud Walls 1Load bearing wall assembly. 2Tested with double 2x4 wood studs 16” OC, a 3” air gap, and 3-1/2” batt insulation on both sides. Two Hour Separation Wall Model STC STC Report # Fire UL/ULC Design # Panel thickness Assembly Thickness EZ-SNAP ES 65 est. UL, 1 hour U3411, U3761, W3131 5/8” 11-1/4”
Walls, Fire, Acoustic, Assemblies, Double, Certainteed, Acoustic and fire assemblies
STC Ratings & Steel Stud Framed Walls - Wall and Ceiling ...
www.wallandceilingbureau.orgSTC Ratings & Steel Stud Framed Walls Sound Transmission Class (STC) is an integer rating of how well a framed wall attenuates sound. Doubling the mass of a wall assembly does not double the STC rating. An empty framed wall (steel studs and a layer of gypsum wallboard on each side) has an STC of approximately 35
Roofs and Walls CAD Details
www.autocaddetails.netDOUBLE FLASHING LAYERED WI POLYETHLENE TO ASSURE--, WATERPROOF MEMBRANE CEILING MATERIAL SOLID GROUT SOLID ~-BLOCKING 2x8 DF FASCIA or '-----2X16 DF FASCIA FASCIA DETAIL for Flat Roof Samples from www.AutoCADDetails.net
ME302YP - BSH Hausgeräte
media3.bsh-group.com30-INCH DOUBLE BUILT-IN OVEN ... - Self-clean mode cleans interior walls and rack supports in as little as 2 hours GENERAL PROPERTIES Heating Modes – Upper Cavity (11) Bake, Variable Broil (hi & low), Roast, Warm, Proof Dough, Convection Bake, Convection Broil, Convection Roast, Pizza, True Convection, Fast