Example: barber
ERIKS - Technical Manual - O-Ring Gland Design Information
Straight-sided grooves are best to pre-vent extrusion or nibbling. Five degree sloping sides are easier to machine and are suitable for pressures up to 1500 psi. (100 bar). The rubbing sur-faces should be 8 to 16 RMS without longitudinal or circumferential scratches. Best surfaces are honed, burnished, or hard chrome plated. Finishes of
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
O-RING.info - Documentation Technique
o-ring.infoELASTOMÈRES O-RINGE / QUAD-RINGE 7 Mélanges standards ERIKS Type N° du Dureté Température Utilisation d’élastomère mélange Shore A +/-5 Mini/Maxi °C
ERIKS - Technical Manual - O-Ring Gland Design Information
o-ring.infoO-ring gland design information. Please contact the local ERIKS repre- ... Application of O-rings in rotary motions In a rotating application a shaft contin-uously rotates in the inside diameter of ... design of seal. • Viton® has much lower friction than NBR or EPDM or Silicone.
O-RING.info - Documentation Technique - JOINTS TORIQUES …
o-ring.infoO-RINGE / QUAD-RINGE JOINTS TORIQUES JOINTS TORIQUES Fig. 1-14 Fig. 1-15 Fig. 1-16 Fig. 1-17 a b LES APPLICATIONS DYNAMIQUES On distingue quatre cas : 1) Translation
Technical Handbook O-rings 14. O-ring Size Charts
o-ring.info14. O-ring Size Charts Note: The AS O-ring Size Chart has a column that shows the Nominal Size along-side the Actual Size. Originally the nominal size was just for a listing of the approximate fractional dimensions of the O-ring. Prior to the common use of dial calipers many people called out a 1 inch by 1-1/4 rt = O-ring, this was a dash -214 ...