Norstar Audio Conferencing Unit user guide

1 Audio Conferencing UnitUser guide i Canadian & US Safety installation Instructions Please Read Carefully WARNING : To avoid electrical shock hazard to personnel or equipment damage observe the following precautions when installing telephone install telephone wiring during a lightning install telephone jacks in wet locations unless the jack is specifically designed for wet touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network caution when installing or modifying telephone exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing)

2 Instructions in the literature accompanying the symbol (if applicable) on the product is used to identify the following important information: For equipment with internal mains supplies: Mains nominal AC voltage 110-120 V~ ; 50/60 Hz Mains nominal AC voltage 220-240 V~ ; 50/60 HzThis equipment may only be connected to the Host equipment ( Norstar or Companion equipment) and may not be be connected directly to the Public Switcherd Telephone Network (PSTN). ii For equipment with external mains adapters: CAUTION : Intended for use in a protected environment. Use only a Nortel supplied or recommended mains power adapter marked as indicated below:The marking on the product indicates compliance with the EU Low Voltage Directive (LVD) and the Electromagnetic Compatibility Directive (EMCD).

3 Mains Supply(Input Voltage)OutputVoltageRated CurrentApproval MarkingsPolarity Marking240 V ac9 V A maximum CLASS II POWER SUPPLY 230 V ac9 V A maximum CLASS II POWER SUPPLY 110 V ac9 V A maximum CLASS 2 POWER SUPPLY - VE+VE- VE+VENRTL/Cor- VE+VE iii Important Safety Instructions Please Read Carefully When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury of persons, including the following:1. Read and understand all instructions . the warnings and instructions marked on the this product from the wall outlet before cleaning.

4 Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement or near a swimming not place this product on an unstable cart, stand or table. The product may fall, causing serious damage to the product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking on not overload wall outlets and extension cords as this can result in the risk of fire or electric spill liquid of any kind on the To reduce the risk of electric shock, do not disassemble this product, but have it sent to a qualified service person when service or repair work is Unplug this product from the wall outlet and refer servicing to qualified service personnel under the follow-ing conditions:a.

5 When the power supply cord or plug is damaged or If the product has been exposed to rain, water or liquid has been spilled on the product, disconnect and allow the product to dry out to see if still operates; but do not open up the If the product housing has been If the product exhibits a distinct change in Avoid using telephone equipment during an electrical storm. There may be a remote risk of electric shock from Do not use the telephone equipment to report a gas leak in the vicinity of the CAUTION : To eliminate the possibility of accidental damage to cords, plugs, jacks, and the telephone equip-ment, do not use sharp instruments during the assembly Save these instructions.

6 Iv CANADIAN AND US REGULATIONS NETWORK CONNECTION (Canada, United States) This device complies with the requirements of Part 68 of the FCC Rules and Industry Canada CS03, Issue 8, for connection to the Host equipment ( Norstar or Companion equipment) only, and may not be connected directly to the Public Switched Telephone Network (PSTN).FCC registration number: This equipment complies with Part 68, Rules and Regulations, of the FCC for connec-tion to Host equipment ( Norstar or Companion equipment) and may not be connected directly to the Public Switched Telephone Network (PSTN). The FCC registration number appears on a sticker affixed to the equip-ment.

7 For more regulatory information, refer to Norstar installation guide that came with your system. EMI/EMCNote : This device complies with Class A EMI requirements when connected to host equipment that meets Class A and Class B when connected to host equipment that meets Class B. For more information about compliance, refer to Norstar installation guide that came with your or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. For Class A Host equipment This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules, and ICES-003 Class A Canadian EMI requirements.

8 Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired limits are designed to provide reasonable protection against harmful interference in a commercial equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-dance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

9 For Class B Host equipment This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, and ICES-003 Class B Canadian EMI requirements. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired limits are designed to provide reasonable protection against harmful interference in a residential installa-tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-dance with the instructions, may cause harmful interference to radio communications.

10 However, there is no guarantee that interference will not occur in a particular installation . v If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.