Multifuse® PTC Resettable Fuses White Paper Preventing Component Circuit Damage from Above Range Current with Reliable Overcurrent Protection Introduction As the ...
MF-RX/72 SERIES, REV. O 03/17 Typical Time to Trip at 23 ˚C DIMENSIONS: MM (INCHES) Specifications are subject to change without notice. The device characteristics and parameters in this data sheet can and do vary in different applications and actual device performance may vary over time.
Features n Multiturn / Cermet / Industrial / Sealed n 5 terminal styles n Tape and reel packaging available n Chevron seal design n Listed on the QPL for styleRJ24 per MIL-R-22097 andRJR24 per High-Rel
Specifications are subject to change without notice. The device characteristics and parameters in this data sheet can and do vary in different applications and actual device performance may vary over time.
Specifi cations are subject to change without notice. Customers should verify actual device performance in their specifi c applications. 4600X Series - Thick Film Conformal SIPs
Features n Special alloy resistor n Power rating at 70 °C: 3 W n Inductance less than 5 nH n RoHS compliant* n AEC-Q200 qualified, automotive grade Applications n Power supplies n Stepper motor drives
NOVEMBER 1997 - REVISED MAY 2007 Specifications are subject to change without notice. Customers should verify actual device performance in their specific applications.
ANOTHER G & G ELECTRIC AND PLUMBING DISTRIBUTORS, INC. INFORMATION SHEET COPYRIGHT 1989 20 These “How-To-Do-It” sheets have been reviewed in June 2007 by a professional Engineer.
Effective January 2016 Fuse Technology: Terminology, Specifications and Device Selection Overview Virtually all electronic devices from portable electronics and consumer devices, automotive,
3 Technical Data TD157004EN Effective May 2016 Low-voltage switched capacitor banks and switched detuned filters EATON www .eaton .com Controller • Visual indication of incorrect CT polarity • Digital display of power factor and number of energized stages • Automatic setting of c/k value (sensitivity based on CT ratio and kvar available)