Example: stock market

VIAVI Solutions Data Sheet VIAVI

VIAVI SolutionsData SheetVIAVICellAdvisor JD785B Base Station AnalyzerSpectrum Analyzer: 9 kHz to 8 GHzCable and Antenna Analyzer: 5 MHz to 6 GHzPower Meter: 10 MHz to 8 GHz Specification* ConditionsJD785B specifications apply under these conditions: yThe instrument has been turned on for at least 15 minutes yThe instrument is operating within a valid calibration period yData with no tolerance are considered typical values yCable and antenna measurements apply after calibration to the OSL standard yTypical and nominal values are defined as: Typical: expected performance of the instrument operating at 20 to 30 C after being at this temperature for 15 minutes Nominal: a general, descriptive term or parameterSpectrum Analyzer (Standard)FrequencyFrequency range9 kHz to 8 GHz Frequency accuracy (Readout frequency x Internal 10 MHz Frequency reference accur)

VIAVI Solutions Data Sheet. VIAVI. CellAdvisor™ JD785B Base Station Analyzer Spectrum Analyzer: 9 kHz to 8 GHz. Cable and Antenna Analyzer: 5 MHz to 6 GHz

Tags:

  Solutions, Sheet, Data, Vivai, Viavi solutions data sheet viavi, Viavi solutions data sheet

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of VIAVI Solutions Data Sheet VIAVI

1 VIAVI SolutionsData SheetVIAVICellAdvisor JD785B Base Station AnalyzerSpectrum Analyzer: 9 kHz to 8 GHzCable and Antenna Analyzer: 5 MHz to 6 GHzPower Meter: 10 MHz to 8 GHz Specification* ConditionsJD785B specifications apply under these conditions: yThe instrument has been turned on for at least 15 minutes yThe instrument is operating within a valid calibration period yData with no tolerance are considered typical values yCable and antenna measurements apply after calibration to the OSL standard yTypical and nominal values are defined as: Typical: expected performance of the instrument operating at 20 to 30 C after being at this temperature for 15 minutes Nominal.

2 A general, descriptive term or parameterSpectrum Analyzer (Standard)FrequencyFrequency range9 kHz to 8 GHz Frequency accuracy (Readout frequency x Internal 10 MHz Frequency reference accuracy + RBW centering + 2 Hz + x Horizontal resolution)Internal 10 MHz Frequency ReferenceAccuracy ppm + aging (0 to 50 C) ppm, after 15 minutes of GPS Lock (0 to 50 C)Aging ppm/yearFrequency SpanRange0 Hz (zero span)10 Hz to 8 GHzResolution1 HzResolution Bandwidth (RBW) 3 dB bandwidth1 Hz to 3 MHz1-3-10 sequenceAccuracy 10% (nominal)Video Bandwidth (VBW) 3 dB bandwidth1 Hz to 3 MHz1-3-10 sequenceAccuracy 10% (nominal)Single Sideband (SSB) Phase NoiseFc 1 GHz, RBW 10 kHz, VBW 1 kHz, RMS detectorCarrier Offset30 kHz100 kHz1 MHz 100 dBc/Hz ( 102 dBc/Hz, typical) 105 dBc/Hz ( 112 dBc/Hz, typical) 115 dBc/Hz ( 120 dBc/Hz, typical)Measurement RangeDANL to +25 dBmInput attenuator range0 to 55 dB, 5 dB stepsMaximum Input LevelAverage continuous power+25 dBmDC voltage 50 V DC2 CellAdvisor JD785B Base Station AnalyzerDisplayed Average Noise Level (DANL)

3 1 Hz RBW, 1 Hz VBW, 50 termination, 0 dB attenuation, RMS detectorPreamplifier Off10 MHz to GHz> GHz to 6 GHz>6 GHz to 7 GHz>7 GHz to 8 GHz 140 dBm ( 145 dBm, typical) 136 dBm ( 140 dBm, typical) 134 dBm ( 138 dBm, typical) 128 dBm ( 134 dBm, typical)Preamplifier On10 MHz to 3 GHz>3 GHz to 5 GHz>5 GHz to 7 GHz>7 GHz to 8 GHz 160 dBm ( 165 dBm, typical) 158 dBm ( 162 dBm, typical) 155 dBm ( 158 dBm, typical) 150 dBm ( 155 dBm, typical)Display RangeLog scale and units (10 divisions displayed)1 to 20 dB/division in 1 dB stepsdBm, dBV, dBmV, dB VLinear scale and units (10 divisions displayed)V, mV, mW, WDetectorsNormal, positive peak, sample, negative peak, RMSN umber of traces6 Trace functionsClear/write, maximum hold, minimum hold, capture, load view on/offTotal Absolute Amplitude AccuracyPreamplifier off, power level > 50 dBm, auto-coupled1 MHz to 8 GHz dB ( dB typical)

4 20 to 30 C after 60-minute warm upAdd dB 10 to 55 C after 60-minute warm upReference LevelSetting range 120 to +100 dBmSetting ResolutionLog scaleLinear scale dB1% of reference levelMarkersMarker typesNormal, delta, delta pair, noise, frequen-cy count markerNumber of markers6 Marker functionsPeak, next peak, peak left, peak right, minimum search marker to center/ start/stopRF Input VSWR1 MHz to 8 :1 (typical)Atten >20 dBSecond Harmonic DistortionMixer level 25 dBm50 MHz to GHz< 65 dBc (typical)> GHz to 8 GHz< 70 dBc (typical)Third-Order Inter-Modulation (third-order intercept.)

5 TOI)200 MHz to 3 GHz+10 dBm (typical)>3 GHz to 8 GHz+12 dBm (typical)SpuriousInherent residual responseInput terminated, 0 dB attenuation, preamplifier off, RBW at 10 kHz, Sweep mode 90 dBm (nominal)Exceptions 85 dBm at MHz, , , and GHz 80 dBm at GHz 75 dBm at MHz and 428 MHz 70 dBm at MHz and MHzInput-related spurious< 70 dBc (nominal)Dynamic Range2/3 (TOI-DANL) in 1 Hz RBW>104 dBat 2 GHzSweep ms to 1000 s24 s to 200 s Span = 0 Hz (zero span)Accuracy 2%Span = 0 Hz (zero span)ModeContinuous, singleGated SweepTrigger sourceExternal, video, and GPSGate length1 s to 100 msGate delay0 to 100 msTriggerTrigger sourceFree run, video, externalTrigger DelayRange Resolution 0 to 200 s6 sMeasurements*Channel powerOccupied bandwidthSpectrum emission maskAdjacent channel powerSpurious emissionsField strengthAM/FM audio demodulationRoute mapPIM detectionDual spectrum* High-power CW signal generator (Option 003) can be set up CellAdvisor JD785B Base Station AnalyzerCable and Antenna Analyzer (Standard)

6 FrequencyRange 5 MHz to 6 GHzResolution10 kHzAccuracy 1 ppmData Points126, 251, 501, 1001, 2001 Measurement ms/point (typical)Measurement AccuracyCorrected directivity 40 dBReflection uncertainty ( + |20log (1+10-EP/20)|) (typical)EP = directivity measured return lossOutput PowerHigh5 MHz to GHz, 0 dBm (typical) GHz to 6 GHz, 5 dBm (typical)Low5 MHz to 6 GHz, 30 dBm (typical) Dynamic RangeReflection 60 dBMaximum Input LevelAverage continuous power +25 dBm (nominal) DC voltage 50 V DCInterference ImmunityOn channel On frequency +17 dBm at > MHz from carrier frequency (nominal) 0 dBm within 10 kHz from carrier frequency (nominal)MeasurementsReflection (VSWR)VSWR range Return loss range Resolution 1 to 65 0 to 60 dB to Fault (DTF)Vertical VSWR range Vertical return loss range Vertical resolution Horizontal range Horizontal resolution 1 to 65 1 to 60 dB 0 to (# of data points 1) x horizontal resolutionMaximum = 1500 m (4921 ft)( x 108) x (VP)/deltaVP = propagation velocityDelta = stop freq start freq (Hz)

7 Cable Loss (1-port)Range Resolution 0 to 30 dB dB1-Port PhaseRange Resolution 180 to +180 Smith ChartResolution Power Meter (Standard)General ParametersDisplay range100 to +100 dBm Offset range0 to 60 dB dB or x W (x = m, u, p)Internal RF Power SensorFrequency range 10 MHz to 8 GHz Span1 kHz to 100 MHzDynamic range 120 to +25 dBmMaximum power+25 dBmAccuracySame as spectrum analyzerExternal RF Power SensorsDirectionalJD731 BJD733 AFrequency range300 MHz to GHz150 MHz to GHzDynamic to 150 W (average)4 to 400 W (peak) to 50 W (average) to 50 W ( peak)Connector typeType-N female on both endsMeasurement typeForward/reverse average power, forward peak power, VSWRA ccuracy (4% of reading + W)1,2 TerminatingJD732 BJD734 BJD736 BFrequency range20 MHz to GHzDynamic range 30 to +20 dBmConnector typeType-N maleMeasurement typeAveragePeakAverage and peakAccuracy 7%1 Optical Power Meter (Standard)

8 Optical Power MeterDisplay range 100 to +100 dBmOffset range0 to 60 dBResolution dB or mWExternal Optical Power SensorsMP-60 AMP-80 AWavelength range780 to 1650 nmMax permitted input level+10 dBm+23 dBmConnector typeType-N female on both endsConnector inputUniversal and mmAccuracy 5%1. CW condition at 25 C 10 C2. Forward power4 CellAdvisor JD785B Base Station Analyzer2-Port Transmission Measurements (Option 001)FrequencyFrequency range 5 MHz to 6 GHz Frequency resolution 10 kHzOutput PowerHigh5 MHz to GHz, 0 dBm (typical) GHz to 6 GHz, 5 dBm (typical)Low5 MHz to 6 GHz, 30 dBm (typical) Measurement SpeedVector ms/point (typical) ms/point (typical)

9 Dynamic Range Vector5 MHz to 3 GHz, 80 dB >3 GHz to 6 GHz, 75 dBat average 5at average 5 Scalar5 MHz to GHz, >110 GHz to 6 GHz, >105 dBMeasurementsInsertion Loss/GainRange Resolution 120 to 100 dB dB2-Port PhaseRange Resolution 180 to +180 Bias-Tee (Option 002)VoltageVoltage range +12 to +32 VVoltage resolution VPower8 W MaxHigh Power CW Signal Generator (Option 003)FrequencyFrequency range 10 MHz to 5500 MHzFrequency reference< 1 ppm maximumFrequency resolution10 kHzOutput PowerRange10 MHz to GHz, 60 to +10 GHz to GHz, 60 to +5 dBmStep1 dBAccuracy dB (20 to 30 C)GPS Receiver and Antenna (Option 010)GPS IndicatorLatitude, longitude, altitudeHigh-Frequency AccuracySpectrum, interference, and signal analyzerGPS lock 10 ppbHold over (for 3 days) 50 ppb (0 to 50 C)15 minutes after satellite lockedConnectorSMA, femaleInterference Analyzer (Option 011)

10 MeasurementsSpectrum analyzerSound indicator, AM/FM audio demodulation, interference ID, spectrum recorderSpectrogram Collect up to 72 hours of dataRSSIC ollect up to 72 hours of dataInterference finderSpectrum replayerDual spectrogramChannel Scanner (Option 012)Frequency Range1 MHz to 8 GHzMeasurement Range 110 to +25 dBmMeasurementsChannel scanner 1 to 20 channelsFrequency scanner 1 to 20 frequenciesCustom scanner 1 to 20 channels or frequenciesBluetooth Connectivity (Option 013)Personal area network (PAN)File transfer profile (FTP)Wi-Fi Connectivity (Option 016)Interface typeUSB LAN CardInterface standardIEEE b/g/nChipsetRealTek, RalinkUSB wireless modeInfrastructure modeWeb-based remote control Internet Explorer, Chrome, SafariInternet protocol versionIPv4, IPv65 CellAdvisor JD785B Base Station AnalyzerGSM/GPRS/EDGE Signal Analyzer (Options 022 and 042)General ParametersFrequ


Related search queries