DEMO ONLY Version - IPC

← Back to document page

PhotosChip ComponentsJ-Lead ComponentsGull Wing ComponentsClass 3Class 2Class 1 IPC 2010 3000 Lakeside Drive, Suite 309-S Bannockburn, IL 60015-1219 +1 (tel.) +1 (fax) email: rights reserved under both international and Pan-American copyright conventions. Any copying, scanning or other reproduc-tions of these materials without the prior written consent of the copyright holder is strictly prohibited and constitutes infringement under the Copyright Law of the United Rev. E 3m Rev. D 4m Rev. D 5m Rev. C 3m Rev. B 3m Rev. A 5m 1st printing 5m Association Connecting Electronics IndustriesDEMO only VersionThis is a promotional sample of the IPC Training and Reference Guide do not use this SAMPLE for training or reference is a not-for-profit association for the electronics industry. Please respect our may order printed copies from IPC at: or call (847) you for viewing this DRM-SMT-E DRM-SMT-EChip ComponentsClass 1Class 2J-Lead ComponentsGull Wing ComponentsClass 3Photos1TABLE OF CONTENTS Introduction 2 Acceptance Criteria 2 Lead Free 2 Classification 3 Terminology 4 Chip Components Class 1 Dimensional Criteria 6 Class 2 Dimensional Criteria 8 Class 3 Dimensional Criteria 10 Solder Conditions Photos 12 J-Lead Components Class 1 Dimensional Criteria 18 Class 2 Dimensional Cri

Class 1 Class 2 Class 3 2 3 Classification Surface mount solder joint requirements are divided into three classes depending on the ultimate use, life …

  Surfaces, Dome, Requirements, Mount, Only, Version, Surface mount, Demo only version