Resistors - learn.sparkfun

Surface mount resistor decoding ... SMD resistors have their own value-marking system. Decoding the Color Bands Through-hole, axial resistors usually use the color-band system to display their value. Most of these resistors will have four bands of color circling the resistor.

Surfaces, Mount, Learn, Marking, Resistor, Sparkfun, Surface mount resistors, Resistors learn

Download Resistors - learn.sparkfun

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Documents from same domain

Series and Parallel Circuits - learn.sparkfun

learn.sparkfun.com

Series and Parallel Circuits a learn.sparkfun.com tutorial Available online at: http://sfe.io/t81 Contents Series and Parallel Circuits Series Circuits Parallel Circuits

Series, Circuit, Parallel, Series and parallel circuits, Series and parallel circuits series circuits parallel circuits

How to Use an Oscilloscope - learn.sparkfun

learn.sparkfun.com

Basics of O-Scopes The main purpose of an oscilloscope is to graph an electrical signal as it varies over time. Most scopes produce a two-dimensional graph with time on the x-axis and voltage on the y-axis.

Oscilloscopes, How to use an oscilloscope

How to Use a Multimeter - learn.sparkfun

learn.sparkfun.com

The first digit on many multimeters is only able to display a '1' so the ranges are limited to1 9.99 instead of 99.99. Hence the 20V max range instead of 99V max range. Warning! In general, stick to DC circuits (the settings on the multimeter with straight lines, not curvy lines).

Multimeter

Serial Peripheral Interface (SPI) - learn.sparkfun

learn.sparkfun.com

Programming for SPI Resources and Going Further Introduction Serial Peripheral Interface (SPI) is an interface bus commonly used to send data between microcontrollers and small peripherals such as shift registers, sensors, and SD cards. It uses separate clock and data lines, along with a select line to choose the device you wish to talk to.

Programming

Light-Emitting Diodes (LEDs) - learn.sparkfun

learn.sparkfun.com

If you connect an LED directly to a current source it will try to dissipate as much power as it's allowed to draw, and, like the tragic heroes of olde, it will destroy itself. That's why it's important to limit the amount of current flowing across the LED. For this, we employ resistors.

Delo

How to Read a Schematic - learn ... - SparkFun Electronics

learn.sparkfun.com

Overview Schematic Symbols (Part 1) Schematic Symbols (Part 2) Name Designators and Values Reading Schematics Resources and Going Further Overview Schematics are our map to designing, building, and troubleshooting circuits. Understanding how to read and follow schematics is an important skill for any electronics engineer.

Overview, Schematics, Overview schematic