TEK MANUAL FOR CONCRETE MASONRY DESIGN …
- 1 - TEK MANUAL FOR CONCRETE MASONRY DESIGN AND CONSTRUCTION a complete manual of facts on designing and building with concrete masonry and related concrete …
Download TEK MANUAL FOR CONCRETE MASONRY DESIGN …
Information
Domain:
Source:
Link to this page:
Documents from same domain
ENERGY CODE COMPLIANCE TEK 6-4B USING ... - …
www.ncma-br.orgNCMA TEK 6-4B 1 An information series from the national authority on concrete masonry technology ENERGY CODE COMPLIANCE USING COMCHECKTM TEK 6-4B
NCMA TEK
www.ncma-br.orgservativelyappliedtoopen-endunits(seeFigure2)thatare either partially grouted or solid grouted, since by code the cells with the open end must be grouted.
NCMA TEK
www.ncma-br.orgAvailable as clear and opaque compounds, the effectiveness of surface treatments depends on their composition and compatibility with the masonry.
HYBRID CONCRETE MASONRY CONSTRUCTION …
www.ncma-br.orgCONSTRUCTION Type I Hybrid Walls Practically speaking, the concept of Type I walls is that the masonry wall is a nonloadbearing shear wall …
ASTM SPECIFICATIONS FOR TEK 1-1F CONCRETE …
www.ncma-br.orgNCMA TEK 1-1F 1 An information series from the national authority on concrete masonry technology ASTM SPECIFICATIONS FOR CONCRETE MASONRY UNITS
NCMA TEK
www.ncma-br.orgNCMA TEK National Concrete Masonry Association an information series from the national authority on concrete masonry technology TEK 3-1C Construction (2002)
GROUTING CONCRETE MASONRY WALLS TEK 3-2A
www.ncma-br.orgTEK 3-2A © 2005 National Concrete Masonry Association (replaces TEKs 3-2 and 3-3A) NCMA TEK National Concrete Masonry Association an information series from the national authority on concrete masonry technology
NCMA TEK
www.ncma-br.orgDeflection criteria for lintels is based on controlling crack-ing in the masonry being supported. Consequently, less deflec-tion is allowed when the lintel supports unreinforced masonry.
KEY INSTALLATION CHECKPOINTS FOR MANUFACTURED …
www.ncma-br.org2 NCMA TEK 20-1 the International Building Code (ref. 11) limits the deflection of wall systems to L/240 for brittle finishes. Concrete and Concrete Masonry Walls Manufactured stone veneer can be directly applied to surfaces of concrete and concrete masonry if they are free
NCMA TEK
www.ncma-br.orgRecommended control joint locations and located where stress concentrations are likely to cause cracks. The joints allow unrestrained longitudinal movement,
Related documents
Inspection Checklist for a Mobile Crane or Boom …
bcmsa.caInspection Checklist for a Mobile Crane or Boom Truck Revision #4, September 10, 2009, Doug Y. 1. Identification REFERENCE