Operational amplifier specifications
Found 6 free book(s)
LT1001 - Precision Operational Amplifier
www.analog.comart of precision operational amplifiers. In the design, processing, and testing of the device, particular atten-tion has been paid to the optimization of the entire distribution of several key parameters. Consequently, the specifications of the lowest cost, commercial tem-perature device, the LT1001C, have been dramatically
LF353-NWide Bandwidth Dual JFET Input Operational …
www.ti.comLF353-NWide Bandwidth Dual JFET Input Operational Amplifier Check for Samples: LF353-N 1FEATURES DESCRIPTION These devices are low cost, high speed, dual JFET 2• Internally Trimmed Offset Voltage: 10 mV input operational amplifiers with an internally trimmed • Low Input Bias Current: 50pA input offset voltage (BI-FET II technology). They
LTC2057/LTC2057HV - High Voltage, Low Noise Zero-Drift ...
www.analog.comZero-Drift Operational Amplifier The LTC®2057 is a high voltage, low noise, zero-drift op-erational amplifier that offers precision DC performance over a wide supply range of 4.75V to 36V or 4.75V to 60V for the LTC2057HV. Offset voltage and 1/f noise are suppressed, allowing this amplifier to …
Low-noise JFET quad operational amplifier
www.st.comLow-noise JFET quad operational amplifier Datasheet -production data Features • Wide common-mode (up to VCC +) and differential voltage range • Low input bias and offset current • Low noise en = 15 nV/ √ Hz (typ) • Output short-circuit protection • High input impedance JFET input stage • Low harmonic distortion: 0.01% (typical)
CHAPTER 1: THE OP AMP - Analog Devices
www.analog.comThe name “op amp” is the standard abbreviation for operational amplifier. This name comes from the early days of amplifier design, when the op amp was used in analog computers. (Yes, the first computers were analog in nature, rather than digital). When the basic amplifier was used with a few external components, various mathematical
Description of STM32F4 HAL and low-layer drivers - User …
www.st.comthe MCU and peripheral specifications. The HAL- and LL-driver source code is developed in Strict ANSI-C, which makes it independent of the development tools. It is checked with the CodeSonar® static analysis tool. It is fully documented. It is compliant with MISRA C®:2004 standard. Description of STM32F4 HAL and low-layer drivers UM1725 User ...