Search results with tag "The jtag"
PM0075 Programming manual - STMicroelectronics
www.st.commicrocontroller using the JTAG protocol, the SWD protocol or the boot loader while the device is mounted on the user application board. I-Code: this bus connects the Instruction bus of the Cortex-M3 core to the Flash instruction interface. Prefetch is performed on this bus.
STM32 ST-LINK utility software description
www.st.comNote: The RESET pin of the JTAG connector (pin 15) must be connected to the device reset pin. The low-power mode is disabled when the user disconnects from the target. The ST-LINK firmware version to be used in case of multi probes selection must be: • V1J13S0 or greater for ST-LINK • V2J21S4 or greater for ST-LINK/V2
UM1075 User manual - STMicroelectronics
www.st.com• JTAG/serial wire debugging (SWD) specific features – 1.65 V to 3.6 V application voltage suppo rted on the JTAG/SWD interface and 5 V tolerant inputs – JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector – Supports JTAG communication – Supports serial wire debug (SWD) and serial wire viewer (SWV) communication