Search results with tag "The parallel"
Teaching the Difference Between Stiffness and Damping
hfu.mech.utah.eduFactor”). For the parallel mass-spring-damper system, the Q factor at the resonant frequency is Q m. k c/ , where m is the mass, k is the spring constant, and c is the damping coefficient. Thus, increasing the spring constant k makes the behavior of the system more elastic and increases the Q factor, while decreasing the spring constant makes the
Getting Started Parallel - Northwestern University
users.iems.northwestern.eduparallel backend to use, otherwise foreach will execute tasks sequentially, even when the %dopar% operator is used.1 The doParallel package acts as an interface between foreach and the parallel package of R 2.14.0 and later. The parallel package is essentially a merger of the multicore package, which
Switch Mode Power Supply (SMPS) Topologies
ww1.microchip.comSep 10, 2007 · converter is connected in parallel to deliver the load. To optimize the input and output capacitors, all the parallel converters operate on the same time base and each converter starts switching after a fixed time/phase from the previous one. This type of converter is called a multiphase synchronous buck converter. Figure 3
Series and Parallel Resonance - ece.rutgers.edu
www.ece.rutgers.eduas the series-resonant circuit and the second as the parallel-resonant circuit. The relevant equations and characteristic bell-shaped curves of the frequency response around resonance are given in section 2.
A Resonant Converter Topology for Bidirectional DC DC ...
www.ijert.orgensure ZVS in a class-E resonant converter, it has to be controlled by frequency change, keeping a constant break between the succeeding ... is equal to the time of the parallel connected capacitor overcharge. During the ZCS switch off time, the L-C tank circuit resonates.
The Parallel Loaded Resonant Converter for the Application ...
ijcsmc.comloaded-resonant converter and it is superior to the conventional parallel resonant converter in terms of light weight, size, simple topology, and easy control. To attain the maximum efficiency we are using zero voltage/current switching is used and it is a square …