Example: biology
A Star Teck® - Teck and tray cable fittings
and enclosed in a metallic sheath of interlocking tape, or a smooth or corrugated tube.” Metal clad cable type MC is rated for use up to 5,000 volts. The National Electrical Code permits use of metallic sheath as an equipment grounding conductor. Metal clad cables are available with a variety of phase conductor insulations such as cross-linked
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Aluminum Lugs - ABB Electrification
tnb.ca.abb.comMaterial: E.C. grade aluminum. Connector bores are coated with HM 53 (an oxide-inhibiting compound) and capped. Mounting holes sized for 1⁄ 2" bolts (9⁄ 16" hole size). Optional suffix “-38” for 3⁄ 8" bolts (13⁄ 32" hole size). • Use with aluminum and copper conductors • Provides high strength and high conductivity
T&B CABLE TRAY METALLIC CABLE TRAY
tnb.ca.abb.comA34 T&B CABLE TRAY METALLIC CABLE TRAY — Aluminum cable tray Straight lengths — Tray bottom types: ladder, ventilated and solid trough Ladder Extra wide aluminum rungs are welded to extruded aluminum I-beam side rails. Every second rung is reversed to allow for easy top or bottom mounting of cable ties and clamps. All edges and welds are
Flexible cord and cable fittings
tnb.ca.abb.comcord and fixture wire 2. UL 514A and 514B – Safety standard for outlet boxes and fittings 3. CEC Section 4 – Conductors 4-012 – Uses of flexible cord 4-040 – Uses of portable power cable 12-010 (4) – Flexible cords in ducts and plenum chambers 22-108 (2) – Bonding conductor for flexible cords for portable equipment
Electrical metallic tubing (EMT) fittings - ABB
tnb.ca.abb.comapproximately 40 percent as much as rigid steel conduit of the same nominal size. EMT can be used, reference CEC Rule 12-1402, for both exposed or concealed work provided that, during installation or afterwards, it is not subjected to severe physical damage. Galvanized steel EMT installed in concrete, on grade or above, generally requires no
Hazardous Locations CEC Classifications - tnb.ca.abb.com
tnb.ca.abb.comGas group designations Two systems of groupings for gases are included in the 1998 CEC: the pre-1998 division gas groups consisting of Groups A, B, C and D; and the IEC system consisting of Groups IIA, IIB and IIC. Both systems are accepted by the CEC. Division gas groups Gorup A acetylene Group B butadiene, hydrogen, manufactured gases
H T&B Liquidtight Systems™ Liquidtight flexible metal ...
tnb.ca.abb.comT&B Liquidtight fittings, engineered to perform in the toughest environments T&B Liquidtight metallic flexible conduit fittings 1. Gland deflects water away from connector and prevents "pooling" of moisture. Look for the distinctive pumpkin appearance of the gland nut. 2. Self-Cleaning Threads inside gland nut keep dirt
Related documents
Controls, Start-Up, Operation, Service and Troubleshooting
chillers.comrefrigerant in an enclosed space can displace oxygen and cause asphyxiation. Provide adequate ventilation in enclosed or low overhead areas. Inhalation of high concen-trations of vapor is harmful and may cause heart irregulari-ties, unconsciousness or death. Misuse can be fatal. Vapor is heavier than air and reduces the amount of oxygen avail-
DIESEL/FUEL OIL - Frost Fighter Inc.
www.frost-fighter.com2.When firing the unit in an enclosed area 3 square feet must be provided to allow the free entry of the air required for operation. 3.For electrical supply, use 3 wire receptacle with “U” ground. 4.Do not operate the unit in partly ventilated areas without a flue pipe or in close proximity to combustible surfaces or materials.