Example: air traffic controller
Back-Up Light or Neutral Safety Switch Kit Installation ...
NOTE: This Kit offers the choice of a Back-Up Light Switch OR a Neutral Safety Switch, Not Both! 5/16"-18 x 1-1/4" This Kit will work with the Lokar Adjustable Column Shift Linkage EXCEPT TH400, 700-R4, 4L60E and 4L80E. Refer to Fig. 1 for the component names. Switch Installation: Step 1: Install the bracket with the switch:
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
700-R4, 4L60, and 4L60E Automatic Case Mount Shifter ...
www.lokar.comFig. 4 If you have a 4 wheel drive application that will not accept the rear mounting bracket, start the 5/16"-24 x 5/8" tension set screws into the tension set screw holes at the front and in the center of the shifter main plate. Set the mounting bracket assembly into place on top of the transmission. Fig. 4
Ford C4 and C6 Hi-Tech Kickdown Kit Installation Instructions
www.lokar.comFord C4 and C6 Hi-Tech Kickdown Kit Installation Instructions Step 5: Con( inued) t Attach the kickdown mounting bracket to the Cable Bracket using the supplied #8-32 x 1/2" button head bolt and nylock nut through the small 3/16" diameter center holes in both brackets, but do
TH400 Electric Kickdown Kit Installation Instructions
www.lokar.comStep 5:The kickdown mounting bracket mounts onto the back side of the Lokar Cable Bracket. The throttle cable adjuster will pass through the top hole in both the new kickdown mounting bracket AND the Cable Bracket. TOLL FREE 1-877-469-7440 • tech@lokar.com • www.lokar.com ® TH400 Electric Kickdown Kit Installation Instructions
TH400 Electric Kickdown Kit Installation Instructions
www.lokar.comStep 5:(Continued)Position the kickdown mounting bracket behind the carburetor bracket so that the 5/16" diameter holes at the top of both brackets are aligned, the small
Ford AOD Hi-Tech Kickdown Kit Installation Instructions
www.lokar.comStep 10:On the passenger side of the transmission near the tail housing, you will find three test ports. The T.V. test port is the one in the middle. Fig. 10 Remove the block off plug from the T.V. test port, and connect an oil pressure gauge with hose (not included) using a …
Throttle Cable Installation Instructions - Lokar
www.lokar.com(NOTE: If a Lokar Kickdown Kit is being used, install the kickdown mounting bracket onto the back side of the Cable Mounting Bracket first.) Then, position the rear adjuster nut so that the threaded part of the throttle cable adjuster is approximately centered in the Cable Mounting Bracket. Reinstall the front adjuster nut. Fig. 3
Related documents
Installation Instructions - Painless Performance
www.painlessperformance.comDetails about the 4L60E and 4L80E Kit Contents Photo 5 Picture and List of what’s provided in this kit. Transmission Harness 6-10 Step-By-Step Instruction Vehicle Harness 11-13 Step-By-Step Instruction EFI Connections 14-15 Step-By-Step Instruction/Diagram 3 Carb or Diesel Connections 16-17 Step-By-Step Instruction/Diagram 4