CABOT'S Crystal Clear Satin - DuSpec

1 DescriptionCABOT'S Crystal Clear Satin is water dispersed polyurethane for a tough "water-white", finish on interior panelling and solubleFast dry, easy clean-upWater white clarityRetains natural colour of timberPolyurethane resinTough hard wearingLow odourIdeal for occupied CABOT'S Crystal Clear Satin on interior panelling, ceilings, furniture and GuideWeatherFor interior use only, not recommended forexterior by splash or spillageHeatUp to 120C. Premature yellowing andembrittlement will occur if subjected tocontinuous water alcohol and resistance to for splashAlkaliSuitable for splashTypical Properties and Application DataGloss LevelSatin 40-50% at 85 degreesThinnerNot requiredGloss Level IndSpread sqm/LVolume free.

2 Dry film is of Level11 g/LSanding PropertiesGoodWet film per coatRecommended 67 mDry film per coatRecommended 20 mTouch Dry30 MinutesRecoat3 HoursClean UpThoroughly clean all equipment with Method Data SheetCABOT'S Crystal Clear SatinDuSpec Data CodeNZDW0833 Page No1 of 3 Issue Issued14/12/2011 DATA SHEETCABOT'S Crystal Clear SatinPRODUCT CODE539-82009 Data Sheet GuideSurface PreparationAll timber surfaces should be thoroughly clean, dry and free from wax, oil, grease and other contaminants. Wash with mineralturpentine if needed to remove wax and grease, allow to dry, and lightly sand dressed surfaces with "00" paper or finer, always indirection of the nail holes with CABOT'S Wood Tone Putty - do not use a linseed oil Procedure and EquipmentStir contents thoroughly before and during use with a broad flat stirrer, to maintain a uniform colour and three coats with three hours drying between coats.

3 Brush is the preferred method of application, always laying off along thegrain. Avoid excessive brushing or uneven film build which can result in air-bubble entrapment. If timber is to be stained, apply onecoat of CABOT'S Interior Stain in selected colour, allow 24 hours drying then apply three coats Crystal very lightly between coats of Crystal Clear . Allow 72 hours to achieve full , roller and sprayHealth and SafetyMSDSN umber14290601 Using SafetyPrecautionsFor detailed information refer to the productlabel and the current Material Safety DataSheet available through CABOT'S Sales andCustomer Service EffectsSplashes to eyes will cause irritation.

4 Prolongedcontact with liquid is harmful and inhalation ofvapour may produce respiratory irritation product is not eye protection, protective clothing not contaminate stormwater with product orproduct washings. Do not pour product downthe drain. Unwanted product should be brushedout on newspaper, allowed to dry and thendisposed of via domestic waste containers should be left open in a wellventilated area to dry out. When dry, recyclethe container via recycling of empty paint containers via recyclingprogrammes may differ between localauthorities. Check with your local council the case of emergency please call 0800 734 607 Precautions and LimitationsDo not apply product if temperature is below 10C or is likely to fall below 10C during the drying content of timber should be close to equilibrium moisture content, usually 10-15%, but not exceeding 15%.

5 For interior use SheetCABOT'S Crystal Clear SatinDuSpec Data CodeNZDW0833 Page No2 of 3 Issue Issued14/12/2011 DATA SHEETCABOT'S Crystal Clear SatinData Sheet and StoragePack A539-82009 Sizes4 Litre 1 Litre 500mlFlash Kg Kg 600gUN NumberNADangerousGoods ClassNAPackageGroupNAShipmentNameNot dangerous special transport and Other marks followed by are registered trademarks. Marks followed by the symbol of are data provided within the DuSpec system is correct at the time of publication, however it is the responsibility of those using this information tocheck that it is current prior to specifying or using any of these coating : Any advice, recommendation, information, assistance or service provided by any of the divisions of DuluxGroup (New Zealand) PtyLtd or its related entities (collectively, DuluxGroup) in relation to goods manufactured by it or their use and application is given in good faith and isbelieved by DuluxGroup to be appropriate and reliable.

6 However, any advice, recommendation, information, assistance or service provided byDuluxGroup is provided without liability or responsibility PROVIDED THAT the foregoing shall not exclude, limit, restrict or modify the rightentitlements and remedies conferred upon any person or the liabilities imposed upon DuluxGroup by any condition or warranty implied byCommonwealth, State or Territory Act or ordinance void or prohibiting such exclusion limitation or modification. Coating systems can be expected toperform as indicated on the DuSpec Spec Sheet so long as applications and application procedures of the individual products are followed asrecommended on the appropriate Product data Sheet.

7 "Orica" "Dulux" "Berger" "Berger Gold Label" "Hadrian" "Walpamur" "Levene" "Acratex" andOther marks followed by are registered trademarks. Marks followed by the symbol are note that this document is only valid for 60 days from the date of (New Zealand) Pty Ltd 150 Hutt Park Road NZ ACN 133 404 118 Data SheetCABOT'S Crystal Clear SatinDuSpec Data CodeNZDW0833 Page No3 of 3 Issue Issued14/12/2011 DATA SHEETCABOT'S Crystal Clear SatinData Sheet