Steelite Roof NZDI1253 - DuSpec | Dulux

1 WaterAir SprayAirless SprayBrushRollerNZDI1253 Steelite RoofPart A684 LineDescriptionSteelite is a gloss acrylic paint ideally suited for primed galvanised metal roofing. It provides excellent opacity, colour retention, and durability, providing a longlasting, high quality finish that is guaranteed for 10 years*.FeaturesWater BasedSelf Priming^BenefitsQuick drying and easy clean-upUsesProperly prepared and primed galvanised metals, roofing GuideWeatherExcellent exterior durabilityHeatResistanceExcellent resistance to normal exterior surface temperaturesWaterResists rain and condensationSolventSensitive to aromatic hydrocarbons and alcoholsAbrasionVery good resistance to abrasionTypical PropertiesGlossLevelGlossThinnerWaterCol ourAvailable in a wide range of factory packaged & tintablecoloursComponents1 Number OfCoats2 ToxicityDry film is lead free and non toxicTouch Dry30 MinsClean UpApplicationMethodApplicationConditions Solids By Volume46 MinMaxRecommendedWet Film Per Coat (microns)54 Dry Film Per Coat (microns)

2 25 Recoat Time (min)2 HoursIndefinateTheoretical Spread Rate (m2/L)12 Version of Powder and Industrial Coatings datasheet NZDI1253 approved on Tuesday, 15 January 2013 8:46:54 PM (UTC)Page 1 of 3 Application GuideSurfacePreparationPREVIOUSLY PAINTED GALVANISED IRONO ccasionally an apparently sound old paint will lose adhesion when recoated, particularly if the new paint is darker in colour. To avoidthis, check the adhesion of the old paint by cutting an 'X' through a clean area of the film with a sharp knife, press cellulose tape firmlyacross the cut and rip it off. If the old paint comes off with the tape it should be removed before repainting.

3 Remove dust, grease, and anyloose or flaking paint by scrubbing with a solution of Dulux House Wash using a stiff bristle brush (not a wire brush). Rinse with waterand allow to dry. Apply 1 coat of Steelite Galv. Iron Primer to any bare surfaces. Remove any red rust with a wire brush and spot primewith a suitable GALVANISED IRON, ROOFING, DOWNPIPES & GUTTERING (ZINCALUME)Wash with detergent in water using a stiff bristle brush (not a wire brush). Rinse with water and allow to dry. Remove any red rust with awire brush and spot prime with a suitable primer. Galvanised iron must not be left to weather , particularly in salt or chemical areas.

4 Forbest results, especially in coastal or geothermal areas, the application of 1 coat of Steelite Galv. Iron Primer is IRONR emove all rust by scraping, sanding or wire brushing. Apply 2 coats of Steelite Galv. Iron Primer .ApplicationProcedureAndEquipmentBrush, roller or paint well before use with a broad flat paddle using an up and down scooping action. Apply 3 even coats of Steelite Roof ensuringthat each coat is completely dry before applying the And SafetyUsingSafetyPrecautionsFor detailed information refer to the product label and the current Material Safety Data Sheet available through Dulux Sales and CustomerService to the eye may cause eye irritation.

5 Whenspraying, inhalation of mists may produce product is not eye protection and when spraying wear a not contaminate stormwater with product or productwashings. Do not pour product down the drain. Unwantedproduct should be brushed out on newspaper, allowed todry and then disposed of via domestic waste containers should be left open in a well ventilatedarea to dry out. When dry, recycle the container viarecycling programmes. Disposal of empty paint containersvia recycling programmes may differ between localauthorities. Check with your local council the case of emergency, please call 0800 734 607 Precautions And Limitations* Steelite Roof will not blister, flake or peel for 10 years, provided it is applied on properly prepared surfaces as per the label directions.

6 This guarantee doesnot cover paint failure caused by any breakdown of coatings applied previously. If Steelite Roof does not perform as specified above, then Steelite willprovide free of charge paint to rectify the affected not apply if surface temperature is below 10C or when the temperature may fall below 10C during the drying period. Rain or dew settling on the film during the drying period will damage the film. Where roofs are used for the collection of drinking water it is recommended to disconnect tank inlets to allow the first few showers of rain to wash awaysurface active agents from the paint .

7 ^ For best results, especially in coastal or geothermal areas, we recommend the application of 1 coat of Steelite Galvanised Iron of Powder and Industrial Coatings datasheet NZDI1253 approved on Tuesday, 15 January 2013 8:46:54 PM (UTC)Page 2 of 3 Transport And StoragePack A684 LineShipmentNameNot dangerous goods. No special transport requirementsSizeWeight4L Kg PointNAUNN umberNADangerousGoodsClassNAPackageGroup NADisclaimerDulux and Other marks followed by are registered trademarks. Marks followed by the symbol of are data provided within the DuSpec system is correct at the time of publication, however it is the responsibility of those using this information to check that it is current prior tospecifying or using any of these coating.

8 Any advice, recommendation, information, assistance or service provided by any of the divisions of DuluxGroup (New Zealand) Pty Ltd or its related entities(collectively, DuluxGroup) in relation to goods manufactured by it or their use and application is given in good faith and is believed by DuluxGroup to be appropriate and , any advice, recommendation, information, assistance or service provided by DuluxGroup is provided without liability or responsibility PROVIDED THAT the foregoing shall notexclude, limit, restrict or modify the right entitlements and remedies conferred upon any person or the liabilities imposed upon DuluxGroup by any condition or warranty implied byCommonwealth, State or Territory Act or ordinance void or prohibiting such exclusion limitation or modification.

9 Coating systems can be expected to perform as indicated on the DuspecSpec Sheet so long as applications and application procedures of the individual products are followed as recommended on the appropriate Product data Sheet. "Orica" " Dulux " "Berger""Berger Gold Label" "Hadrian" "Walpamur" "Levene" "Acratex" and Other marks followed by are registered trademarks. Marks followed by the symbol are note that this document is only valid for 60 days from the date of (New Zealand) Pty Ltd 150 Hutt Park Road NZ ACN 133 404 118 Version of Powder and Industrial Coatings datasheet NZDI1253 approved on Tuesday, 15 January 2013 8:46:54 PM (UTC)Page 3 of 3