CLD Structural Cavity Batten Technical Specification

This specification covers the use of Titan Façade Panel on buildings, where the maximum wind pressure exerted on the building façade is up to 2.5kPa (ULS). This specification is intended for use by architects or designers/ specifier and installers who …

Fullscreen Download

Tags:

Specification, Technical, Pressure, Technical specifications

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of CLD Structural Cavity Batten Technical Specification

Documents from same domain

Vertical Installation Technical Specification

www.jameshardie.co.nz

This specification also covers the installation of Linea Oblique Weatherboard on projects, which are subject to specific engineering design (SED) up to a wind pressure of 2.5kPa (ULS). 1.3 DETAILS Various typical Linea Oblique Weatherboard vertical construction details are provided in the Details section of this document.

Installation, Specification, Engineering

Fire & Acoustic - James Hardie

www.jameshardie.co.nz

3.1 External Walls - Timber Frame 8 3.2 External Walls - Steel Frame 10 3.3 Parapet & Wing Walls ... S - StriaTM Cladding ... Refer to recommended safe working practices in each specific product technical specification or installation manual

Specification, Technical, External, Technical specifications, Cladding

Technical Specification - jameshardie.co.nz

www.jameshardie.co.nz

Linea® Weatherboard Technical Specification April 2016 New Zealand 3 1 Application and scope 1.1 APPLICATION Linea® Weatherboard is …

Technical

Design Manual - James Hardie

www.jameshardie.co.nz

The specifier or other party responsible for the project must run through a risk matrix analysis as per E2/AS1 to determine which construction method is applicable to install the external cladding on the project. The designer must also ensure that the bracing capacities published in this specification are appropriate for the intended application.

Manual, Applications, Design, Risks, Construction, Design manual

Design Manual - jameshardie.co.nz

www.jameshardie.co.nz

Fire and Acoustic Design Manual August 2017 New Zealand 3 1 Introduction readers are familiar with the relevant James Hardie cladding and lining product literature.

James, Lining, Cladding, Hardie, James hardie cladding

Design Manual - James Hardie

www.jameshardie.co.nz

Figure 1: Vertical junction between Linea™ Weatherboard and James Hardie flat sheet cladding Figure 2: Vertical junction between Linea™ Weatherboard and James Hardie flat sheet cladding 4 James Hardie Cladding Junction Details Design Manual November 2016 New Zealand Flexible underlay Linea™ Weatherboard Scriber 60 x 3.15mm jolt head

James, James hardie, Hardie

jameshardie.co.nz CLD Structural Cavity Batten

www.jameshardie.co.nz

Portland cement, ground sand, cellulose fibre and water. The product is easily identified by the name 'Stria Cladding' printed on the back of the panels. CLD Structural Cavity Batten is manufactured using a low density fibre cement formulation. The basic composition is Portland cement, ground sand, cellulose fibre, water and proprietary additives.

Structural, Cement, Cld structural cavity batten, Cavity, Batten, Portland, Portland cement