Code of practice - Internal wet area membrane systems
Further, this Code of Practice may be used to develop recommended training criteria and set installation methodology benchmarks for the industry. 1.2 Scope 1.2.1 Wet Areas Covered This Code of Practice is applicable to internal wet-area waterproof membrane systems, including their substrates, for bathrooms, kitchens and laundries within buildings.
Tags:
System, Code, Internal, Practices, Area, Code of practice, Membrane, Internal wet area membrane systems
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Advertisement
Documents from same domain
C/AS2 - Acceptable Solution for Acceptable Solution for ...
www.building.govt.nzC/AS2 Acceptable Solution for Buildings with Sleeping (non institutional) (Risk Group SM) For New Zealand Building Code Clauses C1-C6 Protection from Fire
Earthquake geotechnical engineering practice
www.building.govt.nzEarthquake geotechnical engineering is a highly specialised field. As such the investigations for this need to be developed and carried out by an appropriately qualified and experienced geotechnical engineer or engineering geologist (referred to herein as the geotechnical professional). For the purposes of this document ‘geotechnical
Building work that does not require a building consent
www.building.govt.nzGUIDANCE Building Act 2004 THIRD EDITION 2014 - AMENDED AUGUST 2017 Building work that does not require a building consent
E2 External Moisture
www.building.govt.nzFor single- and two-storey concrete and concrete masonry construction within specific limitations: E2/AS3. For light steel framed buildings up to 3 storeys, within specific limitations: E2/AS4. E2.3.3 Ground contact or proximity All walls, floors and structural elements in ground contact or proximity, except for buildings where external
Module 6: Earthquake resistant retaining wall design
www.building.govt.nzguidance on earthquake design aspects for retaining . structures that are not well covered in these handbooks or elsewhere. The main objective is to identify situations where seismic design of retaining structures should be considered, to provide the necessary seismic parameters, and to identify key issues relating to seismic design.
Design, Seismic, Structure, Walls, Module, Resistant, Seismic design, Retaining, Earthquake, Module 6, Retaining structures, Earthquake resistant retaining wall design
Worked Example 4 | Design of a tied-back retaining wall to ...
www.building.govt.nzDesign of a tied-back retaining wall to resist earthquake loading . Worked example to accompany MBIE Guidance on the seismic design of retaining structures for residential sites in Greater Christchurch (Version 2) November 2014 . Tied-back retaining walls were used originally as a substitute for braced retaining walls in deep excavations.
Design, Seismic, Structure, Walls, Loading, Seismic design, Retaining, Earthquake, Sisters, Retaining structures, Retaining wall to resist earthquake loading
Acceptable Solutions and Verification Methods
www.building.govt.nz4.2 Sizing of downpipes 42 4.3 Installation of downpipes 42 5.0 Roof Gutters 42 5.1 Size of roof gutter 42 5.2 Materials44 5.3 Gradients44 5.4 Thermal movement 44 5.5 Overflow outlets 44 Appendix A Rainfall intensities 45 Index 47 Contents Amend 4 Dec 2000 Amend 4 …
Verification, Solutions, Methods, Acceptable, Roof, Appendix, Sizing, Acceptable solutions and verification methods
Acceptable Solutions and Verification Methods
www.building.govt.nz4.2 Sizing of downpipes 42 4.3 Installation of downpipes 42 5.0 Roof Gutters 42 5.1 Size of roof gutter 42 5.2 Materials44 5.3 Gradients44 5.4 Thermal movement 44 5.5 Overflow outlets 44 E1/AS1 Appendix A Rainfall intensities 45 Acceptable Solution E1/AS2 52 1.0 AS/NZS 3500.3 Stormwater Dec 2000 drainage52 Index 56 Contents Amend 4
Verification, Solutions, Methods, Acceptable, Roof, Appendix, Sizing, Acceptable solutions and verification methods
Commentary for Acceptable Solutions C/AS1 to C/AS7 ...
www.building.govt.nzDecember 2013. Contents Acceptable Solutions C/AS1 to C/AS7 Part 1: General 2 ... 4.11 Protected shafts 31 4.13 Floors 32 4.14 Subfloor spaces 32 ... INNOVATION AND EMPLOYMENT – 15 FEBRUARY 2013 I 1 Part 5: Control of external fire spread 34 5.1 General principles 34 5.2 Horizontal fire spread from external walls 36 5.5 Table method for ...
Constructing Cavities - Building Performance
www.building.govt.nzTable 23 (’Properties of roof underlays and building wraps‘). Install the wall underlay directly over the framing. Install the cavity battens directly over the wall underlay as described in Cavity battens on page 9. No additional wall underlay is needed between the wall cladding and the cavity battens except in the following situations.
Building, Constructing, Wrap, Cavities, Building wraps, Constructing cavities
Related documents
Manual tasks code of practice - Department of Commerce
www.commerce.wa.gov.authis document replaces the Western australian Code of practice: Manual handling and the National code of practice for the prevention of occupational overuse syndrome, as approved codes of practice in Western australia. this code of practice applies to all workplaces in Western australia covered by the oSH act. it provides:
Records Management Code of Practice 2021
www.nhsx.nhs.ukRecords Management Code of Practice 2021 Introduction The Records Management Code of Practice for Health and Social Care 2021 (from this point onwards referred to as the Code) is a guide for you to use in relation to the practice of managing records. It is relevant to organisations working within, or under contract to, the NHS in England.
Code of Practice - Safe Work Australia
www.safeworkaustralia.gov.auA code of practice can assist anyone who has a duty of care in the circumstances described in the code of practice. Following an approved code of practice will assist the duty holder to achieve compliance with the health and safety duties in the WHS Act and WHS Regulations, in relation to the subject matter o f the code of practice. Like ...
Confined spaces Code of Practice 2021
www.worksafe.qld.gov.auThe Confined spaces Code of Practice is an approved code of practice under section 274 of the Work Health and Safety Act 2011 (the WHS Act). An approved code of practice is a practical guide to achieving the standards of health, safety and welfare required under the WHS Act and the Work Health and Safety Regulation 2011 (the WHS Regulation).
AMT Code of Practice - sections
mobile.amt.org.aubreach of this Code of Practice. The Code clearly and comprehensively sets out AMT’s position if called upon to give Expert Witness evidence in court cases for criminal negligence or assault. It is the massage therapist’s responsibility to formulate a risk management framework around the standards articulated in this Code of Practice. In ...
Code of practice for the welfare of laying hens and pullets
assets.publishing.service.gov.ukwhom he has actual care and control is responsible. Regulation 6 of the Welfare of Farmed Animals (England) Regulations 2007 states: (1) A person responsible for a farmed animal— (a) •must not attend to the animal unless he is acquainted with any relevant code of practice and has access to the code while attending to the animal; and
Governance Code on Public Appointments
assets.publishing.service.gov.ukStatutory basis for this Code 1! 1.! Introduction 2! 3.! The role of Ministers 3! 4.! The role of the Commissioner for Public Appointments 5! 5.! The role of Advisory Assessment Panels 5! 6.! The role of Senior Independent Panel Members 6! 7.! The role of Departments 7! 8.! Transparency 8! 9.! Standards in public life and handling conflicts 8! 10.!
Code of practice on confidential personal information
www.cqc.org.ukCQC’s Code of practice on confidential personal information September 2016 7 . PRACTICE 2: Using confidential personal information . As far as it is possible and practicable to do so, we will keep people informed about how, why and when we need to obtain, use and disclose their confidential personal information .