G2R - Omron

DC Power Relays

High-voltage, High-current Loads • A compact relay (73 x 36 x 67.2 mm (L x W x H)) capable of switching 400-V 60-A DC loads. (Capable of interrupting 600 A at 300 VDC max.) • The switching section and driving section are gas-injected and hermetically sealed, allowing these compact relays to interrupt high-capacity loads.

  High, Voltage

G7L - Omron

• Miniature size for maximum switching power, particularly for inductive loads. • Flame-resistance materials (UL94V-0-qualifying) used for all insulation material. • Quick-connect, screw, and PCB terminals, and DIN track mounting available. • Conforms to UL, CSA, TUV and meets IEC950. • Safety design with contact gap of 3 mm.

  Maximum, Load

G6S - Omron

Electrical 100,000 operations min. for AC (at 1,800 operations/h with rated load) 100,000 operations min. for DC (at 1,200 operations/h with rated load) Failure rate (P level) (reference value) *3 10 μA at 10 m VDC Ambient operating temperature-40°C to 85°C (with no icing or condensation), and -40°C to 70°C (with no icing or condensation)

  Electrical

G6B - Omron

3 G6B PCB Power Relay G 6 B Models for Ultrasonically Cleanable Note: When ordering, add the rated coil voltage to the model number. Example: G6B-1114P-US DC5 However, the notation of the coil voltage on the produc t case as well as on the packing will be marked as @@ VDC.

Solid State Relays Common Precautions

2.Inductive Noise Do not wire power lines alongside the input lines. Inductive noise may cause the SSR to malfunction. If inductive noise is imposed on the input terminals of the SSR, use the following cables according to the type of inductive noise, and reduce the noise level to less than the must release voltage of the SSR.

  Power, Noise, Reduces

CSM PCB Con CN J 1 3 - omronfs.omron.com

A-20 最新の商品情報・便利な情報は www.fa.omron.co.jp/ コネクタ 共通の注意事項 コネクタ 共通の注意事項 挿抜作業について ・通電中の挿抜作業時および抜去後に、コネクタの接点 …

  Nomor

CSM XM2 XM3 AC DS J 1 8 - omronfs.omron.com

2 最新の商品情報・便利な情報は www.fa.omron.co.jp/ XM2/XM3 Dサブコネクタ X M 2 ／ X M 3 注1. 1個のコネクタに固定具は2個必要です。 注2. 形XM3K/Lには取付できません。

  Nomor

Solid State Pressure Sensors D8M - omronfs.omron.com

Compact D8M solid state pressure sensors provide reliable detection for gas and air inflow for burner controls in water heaters, furnaces and other gas-fired devices.

  States, Solid, Sensor, Solid state

G5V-2 - omronfs.omron.com

2 G5V-2 Low Signal Relay G 5 V-2 Ratings Coil Note 1. The rated current and coil resistance are measured at a coil temperature of 23°C with a tolerance of ±10%. 2.Operating characteristics are measured at a coil temperature of 23°C.

G2RL - Omron

Test conditions: Shock is applied in ±X, ±Y, and ±Z directions three times each with without energizing the relays to check the number of malfunctions. Requirement: None malfuction 100 m/s2 Sample: G2RL-24 12 VDC Number of relays: 5 pcs Test conditions: Shock is applied in ±X, ±Y, and ±Z directions three times each with without energizing

  Tests

Rectifier circuits & DC power supplies

Nov 01, 2015 · Resistor represent a load. We are trying to deliver DC power to the load. Diode is off until V S > 0.7 V. EE 201 rectifiers – 4 Y5(W) 9Ssin ...

  Power, Load

G6B - Omron

2.Use the -FD type for inductive load and switching load which contact roughening is small. Item Rated voltage Rated current (mA) Coil resistance (Ω) Must operate voltage (V) Must release voltage (V) Max. voltage (V) Power consumption (mW) % of rated voltage 5 VDC 40 125 70% max. 10% min. 160% (at 23°C) Approx. 200 6 VDC 33.3 180 12 VDC 16.7 ...

  Power, Load

Power Transformer Factory Test using IEEE Standards

power level specifications shall apply for conditions with all ventilation fans ON, and for both no load (open secondary) and rated load operating conditions." Sound pressure vs. sound power Sound measurement under load –Measure the winding sound during heat run –Measurements under load logarithmically added to core noise 50 Test sequence

  Power, Load