Example: barber
NI 9472 Datasheet - National Instruments
• 250 Vrms, CAT II, channel-to-earth isolation (screw and spring terminal); 60 VDC, CAT I, channel-to-earth isolation (DSUB) The NI 9472 is a digital output module for CompactDAQ and CompactRIO systems. Each channel is compatible with 6 V to 30 V signals and features 2,300 Vrms of transient
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Using Acoustic Beamforming for Pass-By Noise …
www.ni.comUsing Acoustic Beamforming . for Pass-By Noise Source Detection . NATIONAL INSTRUMENTS. APPLICATION NOTES. Abstract. This application note discusses a technique known as beamforming for determining noise location of passing
GETTING STARTED GUIDE to ±10 V, 16 Bit, 250 …
www.ni.comMeasurement Category I is for measurements performed on circuits not directly connected to the electrical distribution system referred to as MAINS voltage.
NI 6509 User Guide and Specifications - National …
www.ni.comUSER GUIDE AND SPECIFICATIONS NI 6509 This document contains information about using the NI PCI-6509, NI PXI-6509, and NI PCIe-6509 data acquisition devices with the
NI 6528/6529 User Guide and Specifications - …
www.ni.comNI 6528/6529 User Guide and Specifications 6 ni.com Operate the DIO device only at or below Pollution Degree 2. Pollution is foreign matter in a solid, liquid, or gaseous state that can reduce dielectric
PXIe-5820 Getting Started Guide - National …
www.ni.comElectromagnetic Compatibility Guidelines This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications.
DEVICE SPECIFICATIONS NI 6722/6723
www.ni.comDEVICE SPECIFICATIONS NI 6722/6723 This document lists the specifications for the NI 6722/6723 analog output devices. The following specifications are typical at 25°C unless otherwise noted.
NI cRIO-9030 Specifications - National Instruments
www.ni.comSPECIFICATIONS NI cRIO-9030 Embedded CompactRIO Controller with Real-Time Processor and Reconfigurable FPGA This document lists the specifications for the National Instruments cRIO-9030.
NI PS-15 Power Supply User Manual and …
www.ni.com©National Instruments Corporation viii NI PS-15 Power Supply User Manual About This Manual The NI PS-15 Power Supply User Manual describes the features and specifications of the NI PS-15 power supply and contains information
NI cDAQ -9191
www.ni.comDigital output sample clock frequency Streaming from application memory System-dependent Regeneration from FIFO 0 MHz to 10 MHz Finite 0 MHz to 10 MHz
NI PXIe-1435 User Guide and Specifications - …
www.ni.comNI PXIe-1435 User Guide and Specifications The NI PXIe-1435 (NI 1435) is a PXI Express (PXIe) image acquisition device that supports Base, Medium, Full, and Extended Full configuration Camera Link cameras and supports Power over Camera
Related documents
GETTING STARTED GUIDE to ±10 V, 16 Bit, 250 kS/s ... - NI
www.ni.comContinuous 250 Vrms, Measurement Category II Withstand 2,300 Vrms, verified by a 5 s dielectric withstand test 1 The maximum voltage that can be applied or output between AI and COM without creating a safety hazard. 2 This specification is valid only up to 2,000 m.
Micro-D MWDM Insulated Wire Metal Shell Connectors - …
cdn.glenair.com600 VRMS . Fluoropolymer (TFE) J – M22759/33. 600 VRMS Modified Cross-Linked Tefzel® (ETFE) E – NEMA HP3-EB. 600 VRMS Type E M16878/4 (TFE) Wire Color. 1 – White . 2 – Yellow. 5 – Color-Coded Stripes Per MIL-STD-681 (up to 51 colors) 7 – Ten Color Repeating. Wire Length Inches. 18 - Wire Length In Inches. “18” Specifies 18 ...
Electrical Specifications
seielect.com(Vrms) (1) 350 250 500 350 200 400 Type / Code Mil Ref Power Rating (W) @ 70ºC TCR (ppm/ºC) Maximum Overload Voltage (Vrms) RNF2 - 2 RNF12 RN 60 RNF1 RN 65--1 - 2.2M - 100 - 100K-10 - 1M 2KPLF5DQJH DQG7ROHUDQFH--10 - 1M 0.25 0.5 1 49.9 - 1M-1 - 10M--1 - 22M 100 - 100K-RNF18 RN 50 0.125 200 400 ¥3 5
DS1000Z-ESeries
beyondmeasure.rigoltech.comCAT I 300 Vrms, CAT II 100 Vrms, transient overvoltage 1000 Vpk Horizontal Timebase Scale 2 ns/div to 50 s/div Maximum Record Length 24 Mpts Timebase Accuracy [1] ≤±25 ppm Clock Drift ≤±5 ppm/year Maximum Delay Range Negative delay: ≥1/2 screen width Positive delay: 1 s to 500 s Timebase Mode YT, XY, Roll Number of X-Ys 1 Waveform ...
Agilent E4438C ESG Vector Signal Generator - Keysight
www.keysight.comTo within 0.1 ppm of final frequency above 250 MHz or within 100 Hz below 250 MHz. 5. Frequency switching time with the amplitude settled within ±0.1 dB. 6 Specifications for ... √ I2 + Q2 = 0.5 Vrms, nominal] 1 Level accuracy with ALC on π/4 DQPSK or QPSK formats
Surface Mount Multilayer Ceramic Chip Capacitors (SMD ...
content.kemet.com250 V • Capacitance offerings ranging from 0.5 pF up to 0.47 μF • Available capacitance tolerances of ±0.10 pF, ±0.25 pF, ±0.5 pF, ±1%, ±2%, ±5%, ±10%, and ±20% • No piezoelectric noise • Extremely low ESR and ESL • High thermal stability • High ripple current capability Overview KEMET’s C0G dielectric features a 125°C ...
Optocoupler, Phototransistor Output, High Reliability ...
www.vishay.comSFH617A-1 ICEO 250 nA SFH617A-2 ICEO 250 nA SFH617A-3 ICEO 5 100 nA SFH617A-4 ICEO 5 100 nA COUPLER Collector emitter saturation voltage IF = 10 mA, f = 1 MHz VCEsat 0.25 0.4 V Coupling capacitance CC 0.4 pF
Surface Mount Multilayer Ceramic Chip Capacitors (SMD ...
content.kemet.comand 250 V • Capacitance offerings ranging from 0.5 pF up to 0.47 μF • Available capacitance tolerances of ±0.10 pF, ±0.25 pF, ±0.5 pF, ±1%, ±2%, ±5%, ±10%, and ±20% Overview KEMET’s Automotive Grade Series surface mount capacitors in C0G dielectric are suited for a variety of applications requiring proven, reliable performance in
A Series 1-4 Pole Rotary Switches
www.ckswitches.com125 V AC; 1 AMP @ 250 V AC; 350 mA @ 125 V DC (UL/CSA). Carry - 5 AMPS continuous. See page K-6 for additional rat-ings. ELECTRICAL LIFE: Up to 15,000 make-and-break cycles at full load up to 300,000 detent operations. CONTACT RESISTANCE: Below 20 m Ω typ. initial @ 2-4 V DC, 100 mA, for both silver and gold plated contacts.