Transcription of Model 200 HD - Spinner II
{{id}} {{{paragraph}}}
Example: confidence
Model 200 HD - Spinner II
4 gpm at 60 psigModel 200 HD2,000 cc Dirt CapacityInstallation InstructionsParts ListService InstructionsBulletin 71578 Oil Supply to CentrifugeOil supply should, in general, be taken from the highestpressure, hottest source available on the dirty side of thefull-flow oil filter. A1 2-in. pipe or #8 hose supply lineshould be used with a full-opening ball valve installed atthe centrifuge oil inlet so that the unit can be isolated forservice without shutting down the engine. Preferredpressure is 60 to 80 psig but the Spinner II centrifugewill operate efficiently at 40 to 90 psig. Below 35 psig,an internal idle cut-out valve will close to prevent lowoil pressure during low-speed Oil Return to SumpUsing Level Control Base (LCB) PREFERREDThe air-operated control in Part No. 71602 LCB permitsthe Spinner II centrifuge to be installed on the frame rail,base plate or deck in any convenient location near theengine, above or below the sump oil level.
Oil Supply to Centrifuge Oil supply should, in general, be taken from the highest pressure, hottest source available on the dirty side of the full-flow oil filter.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Surface Mount - Mounting Pad Dimensions and, Surface Mount - Mounting Pad Dimensions and Considerations, Reflow Soldering Process Considerations for Surface Mount, JAY CONFIGURE FIT SELECTION GUIDE, CONSIDERATIONS, Dimensions, Surface, Surface Mount, Mechanical, Thermal, and Systems Mounting Concepts, Silicon Controlled Rectifiers, SMT STENCIL DESIGN AND CONSIDERATIONS, 12-Volt Alternator Installation & Operation Manual