Example: tourism industry
J-Link ソフトウエア - エンビテック
2. jtag/swd コネクタ 2.1. jtagモードの接続仕様（20pin） ピン 信号 タイプ 説明 1 vtref 入力 ターゲットの基準電圧： jtag接続前に、ターゲット側の入力電圧の確認のために使用され ます。また、入力コンパレータのロジックレベルの参照を作成する
Tags:
Information
Domain:
Source:
Link to this page:
Related documents
STM32 ST-LINK utility software description
www.st.comNote: The RESET pin of the JTAG connector (pin 15) must be connected to the device reset pin. The low-power mode is disabled when the user disconnects from the target. The ST-LINK firmware version to be used in case of multi probes selection must be: • V1J13S0 or greater for ST-LINK • V2J21S4 or greater for ST-LINK/V2
XDS110 Debug Probe - Texas Instruments
www.ti.com– IEEE 1149.1 JTAG – IEEE 1149.7 cJTAG – ARM serial wire debug (SWD) – ARM serial wire output (SWO) – UART mode only – Transmit and receive UARTs with RS-232C signaling – no hardware handshakes 2.2 USB Host to probe communication is accomplished through a USB link. The probe has a female micro-USB B type connector.
Kinetis K66 Sub-Family - NXP
www.nxp.com1 Ratings 1.1 Thermal handling ratings Symbol Description Min. Max. Unit Notes TSTG Storage temperature –55 150 °C 1 TSDR Solder temperature, lead-free — 260 °C 2 1. Determined according to JEDEC Standard JESD22-A103, High Temperature Storage Life. 2. Determined according to IPC/JEDEC Standard J-STD-020, Moisture/Reflow Sensitivity Classification for …