Transcription of Multipoint Lock Mechanism Replacement Guide
1 Please read this Guide completely before starting. For questions about this and other Andersen products, call -888-888-7020. For the most current version of this Guide visit w w w. a n d e r s e n w i n d o w s . c o m. Consult your local building code official for applicable building codes and regulations. Thank you for choosing Andersen leave this information with Included Installation Guide Multipoint Lock MechanismTools Needed Safety Glasses 1/8" Hex Wrench Phillips ScrewdriverMultipoint Lock Mechanism Replacement Guidefor Andersen 200 Series Hinged Patio Door - Inswing 0 0 0 5 4 8 5 B A Revised 03/13/07 Follow manufacturer s instructions for safe operation of hand/power tools. Always wear safety glasses. Failure to do so may result in injury and/or product installation may affect home security. Make sure lock Mechanism is installed correctly, read and follow each step of this instruction Guide .
2 Multipoint Lock Mechanism Andersen is a registered trademark of Andersen Corporation. All other marks where denoted are marks of Andersen Corporation. 2007-2007 Andersen Corporation. All rights reser 0 0 5 4 8 5 Loosen set screw on underside of exterior handle and remove handles. Keep all hardware and fasteners for cylinder mounting bolts, limiting plate, lock actuator and dummy/lock cylinder. Keep these CylinderCylinder Mounting BoltsLock ActuatorLimiting PlateSupport both handles when loosening set Screw /8" Hex WrenchInterior HandleExterior HandleSupport bothescutcheon plates when loosening Plate BoltsExterior EscutcheonPlateGasketRemove escutcheon plate bolts, interior and exterior escutcheon plates and gasket. Keep these StudInterior Escutcheon PlateTribeca Trim Set ShownRemove screws from Multipoint lock Mechanism and pull out of door panel.
3 Keep screws for Handed DoorRight Handed DoorCheck lock handing against existing lock. If correct go to step 9, if not correct go to step MechanismScrew7 Interior9 Interior8 Interior6 InteriorTurn Phillips head screw to disengage Head ScrewdriverPosition latch so sloped portion contacts latch receiver first. 80 LatchLock Mechanism HousingLatch 0 0 0 5 4 8 5 Grasp latch, pull outward slightly, and rotate 180 . Position Multipoint lock Mechanism into door panel and fasten with latch back into lock Mechanism housing. Lock MechanismDoor PanelScrew11 Interior 0 0 0 5 4 8 5 Interior HandleSupport handles andescutcheon plates when securing Escutcheon PlateInterior Escutcheon PlateEscutcheon Plate BoltsGasketSet ScrewHex WrenchReapply trim set reversing steps 1, 2 and 3. Check hardware operation. Installation is ActuatorLimiting PlateCylinder Mounting BoltsEscutcheonPlate StudDummy/Lock CylinderExterior Handl
