Operation Manual - Brother

1 Operation ManualOperation Manual1 IMPORTANT SAFETY INSTRUCTIONSWhen using this machine, basic safety precautions should always be taken, including the following:Read all instructions before - To reduce the risk of electric shock:1. The machine should never be left unattended while plugged in. Always unplug the machine from the electrical outlet immediately after using and before Always unplug the machine before you change the light the bulb with same type rated 15 - To reduce the risk of burns, fire, electric shock, or injury to persons:1.

2 Do not allow this machine to be used as a toy. Close attention is necessary when the machine is used by or near Use this machine only for its intended use as described in this Manual . Use only accessories recommended by the manufacturer as contained in this Never operate this machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the machine to the nearest authorized dealer or service center for examination, repair, electrical or mechanical Never operate the machine with any air openings blocked.

3 Keep ventilation openings of the machine and foot control free from the accumulation of lint, dust, and loose Never drop or insert any object into any Do not use Do not operate where aerosol (spray) products are being used or where oxygen is being To disconnect, turn the main switch to the symbol { position which represents off, then remove plug from Do not unplug by pulling on the cord. To unplug, grasp the plug, not the Keep fingers away from all moving parts. Special care is required around the machine needle. 11. Always use the proper needle plate.}

4 The wrong plate can cause the needle to Do not use bent Do not pull or push fabric while stitching. It may deflect the needle causing it to break. 14. Switch the machine to the symbol { position to turn it off when making any adjustments in the needle area, such as threading needle, changing needle, threading bobbin, or changing presser foot, and the Always unplug the machine from the electrical outlet when removing covers, lubricating, or when making any other user servicing adjustments mentioned in the instruction Manual . 16. This sewing machine is not intended for use by young children or infirm persons without Young children should be supervised to ensure that they do not play with this THESE INSTRUCTIONSThis machine is intended for household USERS IN THE UK, EIRE, MALTA AND CYPRUS ONLYIf this machine is fitted with a three-pin non-rewireable BS plug then please read the (in the United Kingdom)Main supply (AC 230/240V~, 50Hz)DO NOT cut off the main plug from equipment.}

5 If the plug fitted is not suitable for the power point in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your SURE to replace the fuse only with an identical approved type, as originally fitted and to replace the fuse none the less the main plug is cut off be sure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the main (in the other countries)If the available socket outlet is not suitable for the plug supplied with this equipment, it should be cut off and an appropriate three pin plug fitted.

6 With alternative plugs an approved fuse must be fitted in the : The plug severed from the main leads must be destroyed as a plug with bared flexible cords is hazardous if engaged in a live socket outlet. In the event of replacing the plug fuse, use a fuse approved by ASTA to BS 1362, carrying the mark, rating as marked on replace the fuse cover. Never use plugs with the fuse cover : DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER E , BY THE EARTH SYMBOL OR COLORED GREEN OR GREEN AND wires in this main lead are colored in accordance with the following code:BlueNeutralBrown LiveAs the colors of the wiring in the main lead of this appliance may not correspond with the colored markings identifying the terminals in your plug, proceed as follows.

7 The wire which is colored blue must be connected to the terminal which is marked with the letter N or colored black or wire which is colored brown must be connected to the terminal which is marked with the letter L or colored red or INSTRUCTIONSKeep the carton and packing materials. You may have to take or send the machine to be repaired. If you do not pack it properly, or do not use the right packing material, the machine could be damaged. Please follow the diagram below to unpack the machine. This packing material is designed to prevent damage.

8 Save this packing material if you need to take or send this machine to be READ THESE INSTRUCTIONS BEFORE YOU USE THE use the machine safely1. Make sure you watch the needle carefully while you are sewing. Do not touch the balance wheel, thread take-up lever, needle, or other moving Remember to turn off the power switch and unplug the cord: when you have stopped using the machine; when you are replacing or removing the needle or any other part; if there is a power failure while you are using the machine; if you are checking or cleaning the Do not store anything on the foot give your machine a longer life1.

9 Do not store this machine in direct sunlight or in high humidity conditions. Do not use or store the machine near a heater, iron, halogen lamp or other hot Use only mild soaps or detergents to clean the case. Benzene, thinner, and scouring powders can damage the case and machine, and should never be Do not drop or hit the Always check the Operation Manual before you replace or fit the presser feet, the needle, or any other parts to make sure you fit them repair or adjust the machineIf the machine breaks down, or you need to adjust it, first follow the troubleshooting table in the Appendix of this Operation Manual to inspect and adjust the machine yourself.

10 If the problem is still there, please consult your local authorized SAFETY INSTRUCTIONS .. 1 UNPACKING INSTRUCTIONS .. 3 CONTENTS .. 5 1. KNOWING YOUR SEWING MACHINE ..7 THE MAIN PARTS .. 8 ACCESSORIES .. 9 Optional Accessories .. 9 USING YOUR SEWING MACHINE .. 10 Connecting Plugs .. 10 Main Power and Sewing Light Switch .. 11 Foot Controller .. 11 Checking the Needle .. 11 Replacing the Needle .. 12 Changing the Presser Foot .. 13 Flat-Bed Attachment .. 14 THE CONTROLS .. 15 Pattern Selection Dial .. 15 Patterns and Stitch Names.